Today is 1 full week of adding the Kem-Tek Dichlor. I did a Full panel of tests including CYA. I added the final PM dose of 1 1/3 Cup last night at 9pm. This reading is exactly 12hrs later with having run the Filter for approximately 3.5 hrs during the night.

Temp - 75
FC - 11
CC - 0
PH - 7.4
TA - 80
CH - 40
CYA - 40

Did not add any more of the Dichlor and now I believe I can switch to the BBB method for rest of pool season. Also wanted to point out that I believe I made a mistake in the size of the pool. I do not have measuring tape that is long enough and was basing the size on some old documents I found in basement. I walked the pool using one foot directly in front of the other and came up with 27 steps. I am a size 13 so that roughly one foot each step. Know that sounds ridiculous but should be somewhat accurate. So I need to make all calculations based on a 27' X 4' Round AGP.

Do I need to add Borax and Baking Soda to Increase the TA and PH or are the levels fine where they are? From what I have read I think I need to add 1.4lbs of Borax to bring PH to 7.6 and 2.2lbs of Baking Soda to increase TA to 100.

What should the TA and PH be in regards to my other readings and are they fine at the current level they are at?

Is there a way to calculate dosages properly for future reference. I am having hard time locating the PPM level change for X amount of either Bleach, Borax, and Baking Soda based on my Volume which should now be 17132 gallons.

Pool water is still clear and have had no issues with any type of smell, slimy walls or cloudiness. Running the pump on a cycle of 2.5 hours on and 3.5 hours off continuously for a total of 10hrs a day . Have not needed to Backwash the Filter at all as of yet. The Psi has only increase by 1 for the week according to gauge on pump. Right now the FC is high but will not add bleach till necessary. Would just be nice to know how much to add to increase 1ppm. Thanks!