Bleach

[poser]

By "balance my pool" I mean that I get my ph within limits for a gunite pool with tinted plaster (7.3-7.8) and I get my alkalinity within limits (80-120). I have no control of my cya being high except to try and use bleach instead of trichlor but it goes back to my original question about my TA going up quickly when I use bleach at shock level (8.0-15.0). I use muratic acid and 20 Mule Team Borax to balance. I have a Taylor K1005 test kit. I add small amounts of acid or borax and test again and go from there. I don't want to have to rebalance my PH and TA every time I use bleach.

[CarlD]

High FC can cause false high pH readings. I don't know if it also can generate a false high TA.

Meanwhile, when you say you adjust TA, are you doing it by our ratchet-down, aeration method? You lower pH with acid to about 7.0. Then aerate to raise pH without raising TA. Repeat when pH is back around 7.5 until TA is where you want it.

If you aren't doing it this way, you aren't lowering TA...so I'm wondering if that's it.

Carl

[aylad]

And just to add one more comment--shock level for a CYA of 100 is 25 ppm. The normal, baseline, everyday chlorine levels for a CYA that high is 8-15 ppm. If you've been keeping your chlorine below 8 ppm, that's why you keep getting algae.

See the "best guess" chart linked in Watermom's sig for more info....

Janet

[waterbear]

I don't want to have to rebalance my PH and TA every time I use bleach.

You won't. Bleach is essentially pH neutral and does not cause a permenant rise in TA. Shock level is not normal santizer level. Wait for the sanitizer to drop to baiseline level before testing pH and TA. It's really that easy.