+ Reply to Thread
Page 1 of 2 1 2 LastLast
Results 1 to 10 of 27

Thread: Chem Geek or Mbar - are you there? Iron test question.

Hybrid View

  1. #1
    mbar's Avatar
    mbar is offline Lifetime Member Whizbang Spinner mbar 3 stars mbar 3 stars mbar 3 stars mbar 3 stars
    Join Date
    Dec 1969
    Location
    Ashland, PA
    Posts
    1,009

    Default Re: Chem Geek or Mbar - are you there? Iron test question.

    My advice is to look at your pool - if it looks good, don't worry about it After many years of trying to find out where the metals were coming from, and how to get them out of my water, I came to the conclusion that I would deal with the stains as they come. I hate stains, and I am not a chemist like chemgeek. I just give the benefit of my experience. Now I just enjoy my pool and deal with the dreaded stains if and when they come
    Last edited by mbar; 06-11-2010 at 10:03 AM. Reason: added to answer
    Northeast PA
    16'x32' kidney 16K gal IG fiberglass pool; Bleach; Hayward 200lb sand filter; Hayward pump; 24hrs; Pf200; well; summer: none; winter: mesh; ; PF:7.5

  2. #2
    labdi01 is offline Registered+ Thread Analyst labdi01 0
    Join Date
    May 2010
    Posts
    77

    Default Re: Chem Geek or Mbar - are you there? Iron test question.

    You're right mbar! Thank you so much for sharing your wisdom with me! It's greatly appreciated.

    Right now, I have the pool at shock level to rid a high CC (and I seem to be winning). I have liner stains as well, and they're driving me crazy - because from a distance, it makes my pool look green (liner is blue and white with an alligator-skin pattern) and I feel like I worked too long and hard to get the pool in shape to be left with it looking any less than perfect. ;oP

    Should I hold off on an ascorbic acid treatment after just fighting off a potential bloom and wait for the pool to be stable for a little bit?
    Dianna
    New owner of 24' above-ground pool, vinyl liner, 1 hp pump and sand filter, added D.E.

  3. #3
    mbar's Avatar
    mbar is offline Lifetime Member Whizbang Spinner mbar 3 stars mbar 3 stars mbar 3 stars mbar 3 stars
    Join Date
    Dec 1969
    Location
    Ashland, PA
    Posts
    1,009

    Default Re: Chem Geek or Mbar - are you there? Iron test question.

    Yes hold off. I would get the chlorine to hold steady overnight. Keep the ph low at about 7.2 - when you are finished shocking and the chlorine is holding, then add more sequestering agent. This should take care of the staining. If it does not - then just add a small amount of ascorbic - just a cup or so around the sides of the pool, and put the pool on circulate for a couple of hours. This should do it, you should not have to do a full treatment. The small amount of ascorbic should work without having to rebalance the whole pool again. It will take down the ph so just make sure it does not go under 7.0. When you get to this point it is just a matter of tweaking the water to get the right amount of sequestering agent to keep the stains away.
    Northeast PA
    16'x32' kidney 16K gal IG fiberglass pool; Bleach; Hayward 200lb sand filter; Hayward pump; 24hrs; Pf200; well; summer: none; winter: mesh; ; PF:7.5

  4. #4
    labdi01 is offline Registered+ Thread Analyst labdi01 0
    Join Date
    May 2010
    Posts
    77

    Default Re: Chem Geek or Mbar - are you there? Iron test question.

    Will do mbar!!! Thank you so much! I've come a long way since I took that cover off - and I certainly couldn't have done it without the great people on Pool Forum. I've already learned so much (but what I don't know still could fill a warehouse, I'm sure!).
    Dianna
    New owner of 24' above-ground pool, vinyl liner, 1 hp pump and sand filter, added D.E.

  5. #5
    chem geek is offline PF Supporter Whibble Konker chem geek 4 stars chem geek 4 stars chem geek 4 stars chem geek 4 stars
    Join Date
    Nov 2004
    Location
    California
    Age
    66
    Posts
    2,226

    Default Re: Chem Geek or Mbar - are you there? Iron test question.

    Quote Originally Posted by mbar View Post
    I am not a chemist like chemgeek.
    Just for the record...I'm not a chemist either, don't have a PhD in chemistry, don't work in the industry, etc. I did major in physics & chemistry at Cal Berkeley (field major in physical sciences since they didn't allow a double major in those two due to too many overlapping courses, mostly in math). I rekindled my interest in chemistry when I got my pool 7 years ago and ran into problems when using Trichlor tab/pucks. Did some chemical research and found The PoolForum.

    I totally agree with Marie that if the water is clear and there is no staining, then don't worry about the varying metal measurements -- at least one of them is wrong. The 5 ppm sounds suspiciously high, even if sequestered.

    Richard

  6. #6
    labdi01 is offline Registered+ Thread Analyst labdi01 0
    Join Date
    May 2010
    Posts
    77

    Default Re: Chem Geek or Mbar - are you there? Iron test question.

    That's a lot of math, Chem Geek!

    We do have staining - but we had a brown pool over the course of several days - on 2 separate occasions.

    5 was the highest reading we'd gotten. Right after we filled and it turned brown, it was only a 3. It couldn't have gone up 1.5 times when significant amounts of new water hadn't been introduced. So, I agree with you CG - it is suspicious. Not to mention the fact that the boy who did the test looked all of 12.

    I no longer have the desire to know what the iron level is. I think I was just caught up in it because we fought it for several weeks. Truth is - it's not interfering with anything right now, so who cares. If water turns, I'll filter it out again. Done. Moving on.

    Thanks for putting up with my neuroses!
    Dianna
    New owner of 24' above-ground pool, vinyl liner, 1 hp pump and sand filter, added D.E.

  7. #7
    Watermom's Avatar
    Watermom is offline SuperMod Emeritus Quark Inspector Watermom 4 stars Watermom 4 stars Watermom 4 stars Watermom 4 stars Watermom 4 stars Watermom 4 stars
    Join Date
    Dec 1969
    Location
    Charleston, WV
    Posts
    9,345

    Default Re: Chem Geek or Mbar - are you there? Iron test question.

    Sounds like you have a good handle on your pool at this point. Time to move on and just enjoy it now. Don't fret over every little speck or your pool will end up being all work and no play. Glad Pool Forum was able to help you. Now time for you to go have fun! Good luck.

  8. #8
    labdi01 is offline Registered+ Thread Analyst labdi01 0
    Join Date
    May 2010
    Posts
    77

    Default Re: Chem Geek or Mbar - are you there? Iron test question.

    Thanks Watermom.

    The forum has been vital to our success. I'm sure I'll have other things crop up - but for now - we're almost there!
    Dianna
    New owner of 24' above-ground pool, vinyl liner, 1 hp pump and sand filter, added D.E.

  9. #9
    mbar's Avatar
    mbar is offline Lifetime Member Whizbang Spinner mbar 3 stars mbar 3 stars mbar 3 stars mbar 3 stars
    Join Date
    Dec 1969
    Location
    Ashland, PA
    Posts
    1,009

    Default Re: Chem Geek or Mbar - are you there? Iron test question.

    You may not be a chemist, but I would trust you in any chemistry questions that come along Chem Geek

    Hey my picture turned up!
    Northeast PA
    16'x32' kidney 16K gal IG fiberglass pool; Bleach; Hayward 200lb sand filter; Hayward pump; 24hrs; Pf200; well; summer: none; winter: mesh; ; PF:7.5

  10. #10
    Watermom's Avatar
    Watermom is offline SuperMod Emeritus Quark Inspector Watermom 4 stars Watermom 4 stars Watermom 4 stars Watermom 4 stars Watermom 4 stars Watermom 4 stars
    Join Date
    Dec 1969
    Location
    Charleston, WV
    Posts
    9,345

+ Reply to Thread

Similar Threads

  1. Aqua chem 3-way test kit instructions
    By FNC1962 in forum Testing and Adjusting Pool Water Chemistry
    Replies: 2
    Last Post: 07-10-2012, 12:11 PM
  2. Calling All Chem Geeks (incl. THE Chem Geek) re: storing pool chems
    By elsie in forum Using Chlorine and Chlorinating Chemicals
    Replies: 18
    Last Post: 07-10-2011, 10:20 PM
  3. Ascorbic Acid Treatment - MBAR's suggestion
    By jimmysam in forum Dealing with Stains & Metals, . . . and 'Minerals' & 'Ions',
    Replies: 10
    Last Post: 06-02-2010, 08:01 PM
  4. Trying to keep up w/ Chem Geek
    By ShelleyAnn in forum Pool Equipment & Operations
    Replies: 39
    Last Post: 04-23-2007, 03:30 PM
  5. hth and aqua chem test kits
    By fullhouse in forum Testing and Adjusting Pool Water Chemistry
    Replies: 3
    Last Post: 05-09-2006, 03:33 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts