Trichlor would definitely be a good choice for your pool for now. Start with a couple of pucks and then add more as needed. Keep an eye on your numbers.
Trichlor would definitely be a good choice for your pool for now. Start with a couple of pucks and then add more as needed. Keep an eye on your numbers.
Yes, Tri-chlor releases about 6ppm of stabilizer (CYA) for every 10ppm of free chlorine (FC) it releases. It is also very, very acidic so it's an excellent all-in-one choice for you now. When CYA reaches your target level, you'll want to switch back to bleach/LC. Each gallon of 8.25% bleach will add about 5.5ppm of FC to your water.
Carl
Finally got the K-2006C and a day off! So I have the following results which seem to be pretty good or am I missing something. Any input will be greatly appreciated.
89F
FC=4.2
pH=7.8
TA=130
CH=190
CYA~52
CC=0.4
Those numbers don't look too bad! Make sure you keep your chlorine in range based on your CYA level (Best Guess Chart). A CC of 0.4 is something to keep an eye on. If it goes higher than 0.5, you'll want to shock the pool. Your pH is ok at 7.8 but if it goes to 8.0, you'll want to lower it some.
By the way, use the 10ml sample instead of the 25ml sample when you test. It will make your reagents last longer. You don't really need readings within 0.2ppm; 0.5 is close enough.
Overall those numbers are just fine! Keep up the good work!
Bookmarks