No lights on my SWCG system

[PoolDoc]

From http://www.carvinpool.com/gpc/_media...94180120-3.pdf

The “Power” LED light is OFF
+ Verify the 20 amp ATO fuse located in the circuit board above the cell connector.
+ Check to make sure the power is connected to the control. Be sure the jumpers are set properly.
+ Verify the voltage with a voltmeter and if the input power is functional the problem could be that the circuit breaker could be tripped.
+ Be sure the jumpers are set properly.

Did you verify voltage AT the unit ?

More than that, I can't help with the SWCG. Sorry!

But . . . regarding 'no green', no problem. Head on over to the Walmart at 12182 Highway 92 . . . and get 10 gallons of "Pool Essentials Chlorinating Liquid" from aisle I.30 (maybe, L.30?). That is fresh 10% chlorine bleach.

Your pool has a PF of 5, so each gallon will add about 4 ppm of chlorine. Ideally, pour it in as needed, each evening after 7:30 PM (or, not long b4 sunset)

• If you have no algae, your chlorine level should be at 5% of your stabilizer level, but at least 2 ppm.
• If you have any sign of algae, FC should be 10% of CYA or higher.

PS. How did you end up with a rare Canadian SWCG, all the way down in Georgia?

[Fiveattripp]

Thanks for the reply. Keeping the bleach in.