Cannot start pump and hayward multiport SP0714g11m to prime...
I had everything new installed. Super pump, Hayward Multiport SP0714g11m, SWG, etcc. I attached everything, the pump was in recirculate mode. I filled the pump up to prime it and turn on the pump in recirculate mode. I fill water into the pump basket and it was taking in.... I think I made a mistake. I then turn it off after 15-20mins... realizing the mistake. I changed it to filter. The pump did not start or the filter was working. What can I do. When I turn on the power.. there is a thud sound in the Hayward Salt water generator control area.. it lights up but the pump could not start. There was nothing blown or fuse off as I could not get the pump or the filter to work after turning it clockwise from filter to backwash to rinse. etc. Advise.. pool as a result could not be recirculated. I should not have the pump to recirculate and corrected it to Filter..after I turn off the power and change it to that.Now pump does not make any sound or anything... is it dead. Everything installed was new.. newbie here
https://www.flickr.com/photos/632964...posted-public/
https://www.flickr.com/photos/632964...posted-public/
https://www.flickr.com/photos/632964...posted-public/
https://www.flickr.com/photos/632964...posted-public/
https://www.flickr.com/photos/632964...posted-public/
https://www.flickr.com/photos/632964...posted-public/
https://www.flickr.com/photos/632964...posted-public/
Last edited by phillipjko; 05-02-2018 at 11:26 PM.
18 x 36 Liner Pool. About 1975 built in ground
22,000 gallon, Hayward/ Jacuzzi Sand Filter
Aqua pure Salt Water Generator, Chlorine Tab Dispenser
1Hp super Pump
Bookmarks