+ Reply to Thread
Results 1 to 10 of 15

Thread: algae and too low ph

Hybrid View

  1. #1
    Join Date
    Jun 2014
    Location
    Ohio
    Posts
    6

    Default Re: algae and too low ph

    OK I have bought the unicel filters and hth6 way test kit and BBB....here are the test results.....
    Chlorine 5
    pH 6.8
    Alkalinity 80ppm
    Hardness 120 ppm
    Cya when I read the view tube it is at 30 ppm but I can still see the black dot on the bottom.
    Still have very cloud green water. Draining and refilling is not an option.
    Last edited by PoolDoc; 07-10-2014 at 01:45 PM. Reason: enable signature
    4.5k gal 16' x 42" Summer Escapes pool. PF=27

  2. #2
    PoolDoc's Avatar
    PoolDoc is offline Administrator Quark Inspector PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars
    Join Date
    Jan 2005
    Location
    Georgia
    Posts
    11,386

    Default Re: algae and too low ph

    Ok.

    Go to Walmart & get 4 gallons of PLAIN 8% bleach and 2 boxes of 20 Mule Team Borax. (Both are in the detergent section.)

    Add borax 1/2 box at a time. Make SURE the pump is running. Premix the borax to dissolve it, or add it slowly via the skimmer. Wait 2 hours. Retest pH.

    => If pH is between 7.2 - 8.0, you're good to go.
    => If pH is above 6.8 but below 7.2, add 1/4 box, wait and retest.
    => If pH still at 6.8, add 1/2 box, wait and retest.

    Once your pH is between 7.2 and 8.0, add 1 full gallon of bleach to the pool. Do this after 6pm. Brush the pool completely, including side walls after adding the bleach. Retest in the AM; report results AND pool color and appearance here.

    Good luck!

    PS: Do you have access to a Sams Club?

  3. #3
    Join Date
    Jun 2014
    Location
    Ohio
    Posts
    6

    Default Re: algae and too low ph

    Is it OK to keep the solar cover on? Yes I do have a Sam's Club near but no membership. I will report back in the AM. Also do u add the bleach into the skimmer as well?
    4.5k gal 16' x 42" Summer Escapes pool. PF=27

  4. #4
    PoolDoc's Avatar
    PoolDoc is offline Administrator Quark Inspector PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars
    Join Date
    Jan 2005
    Location
    Georgia
    Posts
    11,386

    Default Re: algae and too low ph

    Add the bleach to the pool, not the skimmer.

    You'll need some dichlor to add stabilizer -- once you have the algae all dead.

    Most dichlor from Walmart, Costco, Home Depot, etc is diluted and blended. Some of the things added can cause problems. Go to the SSR page (http://pool9.net/ssr/ and use the links there to get 10lbs or less of dichlor. You can check Home Depot and Lowes if you like: any dichlor that contains 56% or more available chlorine is OK. Do NOT get trichlor. You'll have to look at the ingredient names: any name that contains "-dichlor-" anywhere in the name is dichlor; likewise any name that contains "-trichlor-" is trichlor.

  5. #5
    Join Date
    Jun 2014
    Location
    Ohio
    Posts
    6

    Default Re: algae and too low ph

    OK this AM results are Cl off the charts above 5 and pH 7.5. The water appearance is still cloudy but a lighter green color. At this point I feel a little frustrated.
    4.5k gal 16' x 42" Summer Escapes pool. PF=27

  6. #6
    PoolDoc's Avatar
    PoolDoc is offline Administrator Quark Inspector PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars
    Join Date
    Jan 2005
    Location
    Georgia
    Posts
    11,386

    Default Re: algae and too low ph

    I'm sorry, but I need to warn you again: clearing a Summer Escapes or Intex pool, once algae has formed, is a SLOW process, more likely to take weeks than days. That's why I encouraged you to drain and refill.

    The Unicel cartridges will help, but not make it a speedy process.

    Back to the pool: if your pool is STILL green, you need higher chlorine levels. Without knowing your CYA level (for which you have to have either a K2006 or an HTH 6-way drops kit), I can't say how much higher.

    I hope you are using an OTO drops kit -- if not, you need to be. Keep raising the chlorine till you get into the OTO orange range. Once the algae finally dies (turns gray), brush the pool completely and HOLD the chlorine level at whatever it is then for several days. Then you can begin letting it drop.

    At that point, if you want to add a clarifier it will likely speed the process somewhat. Chem_Geek has done some testing with different products, and has reported that the BioGuard Polysheen and the GLB Clear Blue work best. But, do NOT overdose -- doing so will actually make things WORSE, not better.

    Be SURE to rotate your Unicels in and out, after cleaning them properly: http://pool9.net/cart-clean.

    You can swim, once the algae is dead. But if the chlorine is still in the orange range, wear old suits: high chlorine will damage them; people are far, far more resistant than swimwear!

    And, be patient -- it WILL be a slow and frustrating process.

    There is a faster way, using floc, but it's tricky, and requires that you have the equipment to vacuum to waste (out of the pool and on to the ground).

    Good luck!

  7. #7
    Join Date
    Jun 2014
    Location
    Ohio
    Posts
    6

    Default Re: algae and too low ph

    I have the hth 6 way test kit when I test the CYA it reads 30 but can still see the black dot at the bottom of the test tube. Which makes me feel its too low. So I should add more bleach and at what rate? Another gallon and keep it there until the algae turns gray? Right now when I teat chlorine its dark yellow.
    4.5k gal 16' x 42" Summer Escapes pool. PF=27

  8. #8
    Join Date
    Jun 2014
    Location
    Ohio
    Posts
    6

    Default Re: algae and too low ph

    Just an update. Pool is clearing up still keeping the chlorine high and pH is staying balanced. I did find 99% dichlor granules at GREAT ESCAPES POOLS AND SPAS. Everywhere I asked wasn't sure what I was talking about. How often do I add this and is it in addtion to the bleach I have been adding 2 cups daily until all the algae is gone to keep the chlorine levels up.
    4.5k gal 16' x 42" Summer Escapes pool. PF=27

+ Reply to Thread

Similar Threads

  1. Avoiding Algae / Removing Algae
    By PoolDoc in forum Dealing with Algae & Slime
    Replies: 1
    Last Post: 07-24-2011, 09:40 PM
  2. Cloudy water...then very small amount of algae...then algae bloom
    By Allan in forum Dealing with Algae & Slime
    Replies: 2
    Last Post: 07-12-2011, 09:49 PM
  3. Wanted: Mustard algae or suspected mustard algae
    By gonefishin in forum Dealing with Algae & Slime
    Replies: 28
    Last Post: 08-30-2007, 08:40 PM
  4. Green algae? Mustard algae?
    By AE340B in forum Dealing with Algae & Slime
    Replies: 6
    Last Post: 07-15-2007, 08:32 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts