REadings from the Mother panel:
Salt 3100
Temperature 90
Voltage 25.9 (I note this is a little above range, but below what it says it would be if it weren't generating.......)
Current 6.33 amps
Output 100 (on superchlor right now)
salinity -2800
Product AL-0
Version 1.58
Cell type T-15

The pool is about a 16,000 gallon, the pump running the system is a new Hayward variable speed, paired with a Sta-Rite System 3 cartridge filter and a Heat Siphon Z700 heater. I had thought that perhaps I had my rpm's set too low but there has been no improvement in output with higher rpm's--the flow through the jets is strong. The only thing I see which is off is that the voltage of the cell is reading higher than usual range, but not as high as it is supposed to read when not generating. My previous cell did the same--the new one has been in for about a week.

On my last water reading a couple of days ago, the pH was low at 6.9 (we've had a lot of rain lately) so I have added some UpH. I have a solar cover on the pool.

Thanks

Ed