New to forum and pools!

[Watermom]

I wouldn't add any floc just yet. We typically only recommend that as a last resort. Give your filter time to do its job. Live algae clogs DE filters fast which is why you are having that issue. Usually best to put a DE filter on recirculate until the algae is dead. Then work to filter it out afterwards.

Instead of using trichlor to add CYA, you can use dichlor which is a faster dissolving granular chlorine that also has CYA in it. It will introduce the dichlor more quickly. But, you have to be careful when buying it as many places sell blended products that have stuff in them you don't want. If you have a Sam's Club near you, you can buy their PoolBrand dichlor which is fine. If not, Amazon sells Kem-Tek which is also ok. You can get the Kem-Tek through our Amazon store. If you use this link (http://pool9.net/amz/), any purchases made earn the forum a small commission which helps to keep us online.

Hope this helps. Let us know if you have any further questions and welcome to the Pool Forum!

[Giants85]

Thanks! Since I was inpatient with the Trichlor I added 4lbs of granular CYA in a sock over the return and 240oz of bleach to get my chlorine levels up last night. Will check my numbers again today when I get home to see where I am at. I believe, based upon the pool calculator, that my CYA should be up to about 30 (after the 3 trichlor pucks disolve and granular CYA gets incorporated into the pool). Since the granular CYA was added last night, which has disovled in the sock and in the pool now will I see my CYA level go up right away or does it take a week to show up on my test kit?

[Watermom]

Wait a few days before you test again to be sure. You don't want to waste the reagent.

[Giants85]

Fc up to 7.2 and ph down slightly to 7.2 (as a result of the cya I assume) will wait a few days to test cya level but added a bit more today and my best guess is that I should be around 45 after all is said and done. Chlorine held well added last night and while today was mostly cloudy it seems as if the chlorine is beginning to hold. Will add some borax tomorrow to keep ph in the 7.6 region. Looks like I may be swimming this weekend!

[Watermom]

Looks like I may be swimming this weekend!

Awesome! That would be great. I intend to get off this computer and do the same! I gotta enjoy my pool, too!

if you will use a 10mL water sample when you do your chlorine tests instead of the 25mL sample, you will save on your reagents. It gives you a reading to the nearest 0.5 instead of 0.2 but that is plenty good enough.

Keep up the good work!

[Giants85]

Thanks ill do that from now on. Can't emphasize enough how helpful this site has been.

[Watermom]

Can't emphasize enough how helpful this site has been.

We are glad to be here and able to help. Let us know if you have further questions.