1. SLOW the water flow. Over-sized pumps force dead algae through under-sized sand filters.
2. Use the polyquat - it *may* help.
The bad news? It appears that the process of forcing algae through sand may fragment the dead bits into even SMALLER and harder to filter bits.
As an alternative:
1. Put the filter on recirculate
2. Add the polyquat (label sized dose, not the whole bottle!)
3. Mix for 4 hours and then turn the pump OFF.
4. Wait 24 hours, and see if the algae is settling.
5. If the algae DOES settle, wait, then vacuum to WASTE.
6. BUT . . . maintain chlorine levels with bleach while the pump is off.
Bookmarks