100,000 gal pool

[PoolDoc]

1. Go to Sams Club and buy (2) 50# buckets of dichlor (~$240). Get a trial membership if you need to do so. Given the amount of dichlor you'll need, a Sams membership will be worth it for you. Together, those will add about 80 ppm of chlorine, and about 70 ppm of stabilizer to your pool.

2. Set your pump timer to run 24/7. Your pump and filter are too small for your pool, and you'll need to run more to make up. Once you've got everything straight, you may be able to switch to low speed.

Get the dichlor from Sams, ASAP. But if you can't do so immediately, add nightly doses of 6 pounds of cal hypo OR 5 gallons of PLAIN 8% household bleach. Do this EVERY evening. Add the doses ONLY in the late evening. If -- and only if -- your pool is crystal clear and algae free, you can cut those doses in 1/2.

Each time the pool is used by a swimmer, add 1 pound or 1 gallon of bleach during or immediately after their swim.

I'm reluctant to encourage you to use "liquid chlorine" (commercial bleach). It's hot summer, and bleach loses strength rapidly, unless it's stored cool (75 degrees or LESS). If you are buying boxed pool bleach, odds are you are NOT getting 10% bleach.

You can compare, though. Add 4 gallons of 10% bleach; test chlorine levels 2 hours later. Tomorrow, add 5 gallons of Walmart 8% bleach, test chlorine 2 hours later. If your 10% bleach is REALLY 10%, you'll see similar FC levels from both.

But maybe not. Your CC level above (1.2 ppm) suggests you've still got goo in the water. If so, to compare the bleach and the LC, you'll need to go for 4 consecutive nights: bleach, LC, LC, bleach, and then average the results for both the bleach and the LC before comparing. Make SURE you add all doses at about the same time each day, LATE in the day.

[4dks1]

I have the 100# of dichlor from Sam's to put in tonight.

Thank you.

[PoolDoc]

You're welcome.

Please note that I was NOT suggesting that you add it all at once; rather that 100# of dichlor was an appropriate quantity for your pool, and will allow you to raise your stabilizer in the process of chlorinating.

[PoolDoc]

Per your email, you should vacuum up all that loose DE.

(BTW, please post online instead of emailing. Thanks!)

[4dks1]

Oh, sorry about that. Here's the post:

Before the grids & manifold were replaced, it seems that the filter was blowing DE powder back into the pool. I'm guessing that's why it's still cloudy, that there's lots of DE powder in the pool. Although, I can see the step now in the deep end!

Per your email, you should vacuum up all that loose DE.

Does the DE powder settle to the bottom of the pool or is it suspended in the water causing the cloudy water?

[PoolDoc]

The DE settles, the dirt that was in the DE is likely suspended.

[4dks1]

New readings
FC. 5.4ppm
CC 2.4ppm
pH 7.0
TA. 150ppm
CH. 440ppm
CYA 50 ppm

Yeah, there is finally FC!