Aquapure/Aqualink salt system

[clowman150]

Thanks for the info. How can I tell which cell or sensor is the issue or are they both having problems? The oldest goes into the aquapure and the newest goes into the aqualink. Aquapure says service with the error codes and aqualink says no flow and shows no codes.

[PoolDoc]

If you have 2 cells, I would assume you can disconnect one at a time, and then see if the error is still thrown. But I've never worked with Jandy controls or cells, so I don't know for a fact that you can do so.

[clowman150]

No I tried that and just gives a new error code. I ordered a new cell and flow sensor. I will let you know if that works. Thanks again!!

[PoolDoc]

Thanks . . . and good luck!