PoolPilot warning check/clean cell???

[PoolDoc]

membership updated . . .

[Poolsean]

mommamichele, Did you get the amps and volts after you put the unit in Boost? If you did, the lower than normal amps and volts would indicate a damaged power module. It may also be due to the power going to the unit. Do you have the AutoPilot powered up whenever the pump turns on, or are you using the AutoPilot as a time clock for the pump?
If the AutoPilot is on it's own circuit breakers, turn them off, wait a few seconds, then turn them back on.
If there are two breakers (usually 220 volts), and one of the two breakers is bad, you may be getting 110 volts to it, which can also give you the lower amps and volts.