Hello all, my first post here.

I just installed a Starite Maxitherm heater where an ancient Teleydne was. The Starite can be connected to a Jandy controller and allow it to be turned on and off by the controller box. Here's my question......

The Jandy controller identifies the circuit with controls the heater as a 24 volt circuit which I connect to the heater. ON the heater is a circuit that the manual identifies as the fireman circuit that is also a 24 volt circuit but has a looping wire that also appears to have an automotive glass fuse in.

If I understand this right I connect that Jandy using the 24 volt circuit to the looped wire on the heater, after cutting it and splicing in the wires from the controller.

I cannot post pictures to describe what I'm seeing. If I could I'd post pics of what I'm seeing.

Does this help to describe anything?