Aquabot Vac stops intermittently

[TomC]

Hi JCASR,

When the aquabot stops moving, does it still pump water? If it does, take it out of the water, turn it over so that you can view the drive gears, turn it on for a second or two, just long enough to see if the drive gears are turning. If they are turning, then you just need to replace the drive belts. There are two of them, they are amber in color and cost about 20 bucks. This is an easy repair and is part of the routine maintenance an aquabot requires.

If the pump motor is not working, then it is not a drive belt issue. The most likely place for the cord to go bad is where it plugs into the power supply. With the aquabot in shallow water close to you, jiggle the plug where it is attached to the power supply and see if you can recreate the intermittent problem. If you can, then you need to replace that plug connector. A shop will charge you about 75 bucks for this repair.

Good Luck,

Tom

[JCASR]

First, thanks to all that replied. Yes, I was hoping for a good, quick (and inexpensive) fix, but your points are all totally valid. Per Tom's suggestion, will take a look to see if the issue is at the plug connector and if not, will go with replacing with a new cord.

Thanks again for your input!
Joe