Looking to buy our first pool.. Wondering about pricing and options..

[BigDave]

You'll need one more 1.5" NPT to 1.5" hose fitting for a backwash hose and you'll need a backwash hose.

Valves are optional but are real handy for doing maintenance on the pump and filter. I have a ball valve on the suction and return sides so I can shut off the water from the pool and clean the pump strainer etc. Unions or Quick-connects make it easy to remove equipment for winter storage or maintenance - I believe hrsdennis linked a True Union ball valve earlier in this thread - this is a valve that has unions built in on each side.

[tbird2340]

Pool being installed today.. They said the 3' corrugated flexible tubing I got to go from the pump/filter isn't what I should use..

Looking in the PDF of the filter it shows to get a 33" vinyl hose (SX201Z1 BUT it says that is for a

18", 21", and 23" system

.. What am I supposed to get for this monster 27" filter?? I can't find jack on their website or documentation..

Thanks

[tbird2340]

I'm sure they sell vinyl tubing at lowes and what not.. Anyone know what kind I need to get? Is it 1 1/2" ID?

Thanks!

[BigDave]

In post #53 hrsdennis suggested flex PVC piping, PVC fittings, glue and thread sealant.

[PoolDoc]

Surprisingly, what appears to be good quality flex is available on Amazon:

1.5" White PVC Flex
1.5" Black PVC Flex

2" White PVC Flex
2" Black PVC Flex

You glue PVC flex just like PVC hard pipe using standard PVC fittings, with one VERY IMPORTANT difference: the pipe tends to slip out of the fitting, so you must hold it in place for 60 - 90 seconds. Otherwise, you'll end up with a bad joint.

Connecting it to your existing gear is something you'll have to work out.

[tbird2340]

Thanks.. Right now I just have (2) 16" x 16" x 1" cement pavers with the pump on one and the filter on the other.. Do you think I need to secure them down and if so how would you recommend doing so?

Thanks