Testing results

[jcwr56]

After a good amount of lower, refilling as to not go low on salt, I was finally able to get the unit to operate where it's working without a low/high salt warning going off. Added acid and CYA (sock) then let the unit operate for 2 hours like the manual suggests for my size pool.

Here are the testing results taken this morning at 7:30.

TC 5
Ph 7.2
ALK 260
Hardness 280
CYA 50

I am also using a solar cover during the daytime.

[PoolDoc]

Looks good.

Just keep your pH in the 6.8 - 7.2 range, and your alkalinity will drop over time. What will happen is that some of the 'alkalinity' will leave as carbon dioxide; your pH will increase; you more acid to get back to 6.8, and it starts over. The more you splash around or 'aerate', the fast it will happen.

But, there's no hurry. You can simply maintain a lowish pH, and let it go at its own pace.

[Watermom]

A couple of links for you to read:

Lowering Alkalinity Step-by-Step

Using Muriatic Acid Safely

[jcwr56]

A couple of links for you to read:

Lowering Alkalinity Step-by-Step

Using Muriatic Acid Safely

Thank you both, I read all the links before I even started messing around with the acid.

Also, I'm keeping track of my readings/use of acid CYA in a log.

[BigDave]

...I am also using a solar cover during the daytime.

Are you using it a night? The solar cover will help more to keep the heat in overnight than it will to catch heat during the day.

[jcwr56]

Unless there's someone in the pool, the solar cover is always on.

Being a smaller pool, I'm noticing evaporation (I see no leaks) of water since we've been in the 90's and my pool is in direct sunlight for all of the day.