Re: Run around at pool store
Hi Mike,
In post #7 in this thread Ben advised to drop pH to 7 using muriatic acid. His goal, if I understand it correctly, was to avoid further scaling since your calcium hardness was very high.
I just looked at the numbers you posted in your chemical chart. The FC and CC look great! Yes, it makes sense to have CC = 0. That's the entire point of it! Good work. Unfortunately, there were no test results for alk (TA) and CH. Ben was hoping to be able to determine why your CH is so high. Until he can look at this thread again and refresh his memory it would be best to keep the pH low. One of the mods will make sure Ben takes a look at this and advises you further.
Oval 12.5K gal AGP; Hayward 19" sand filter; Pentair Dyn 1 HP 2sp pump on timer
[URL="http://www.ellerbach.com/Pool/"]My Pool Pages[/URL]
Bookmarks