Re: Looking for Circupool Review
Thanks Ben for a prompt response that conforts me to know that there won't be any imminet danger to the swimmer.
I have young children that swim very frequently along their firends.
I further lowered the dial to 10% and reduced the pump operation by another hour
I could easily tell when the chlorine is generated as the water becomes cloudy (milky)
Special where the sun shines.
Has this been ever reported that during cholrine generation the water becoming cloudy?
If I observe closely the return jets, I could see whitish return stream.
I wonder if 40K Gallon SWG is too much for a 10K Gallon pool.
It's too bad that the cholorine generation power is time sliced instead of power.
Anyone has an idea how long each cycle is?
1hr?
2hrs?
Simply said (for a 25% setting example) does the AQR generate 15 minutes of choline and then sleep for 45 minutes?
or does it generate 30 minutes of chlorine and then sleep for 90 minutes?
I'd prefer shorter cycles (not that it can be changed) to minimize the concentrated injection effect.
one other thing i noticed, the Average salt measurement hasn't changed at all, even after resetting / recalibrating
It was stuck at 2800, I reset it to 2900 during a peak, and now it is stuck at 2900 even though the instant salt reading is around 2700 (which is only displayed when the unit is actually generating cholrine)
I know 2700 is low end of the chart and I should got up to 3200 PPM (recommended), but I'm a bit reluctant, as this will cause higher concentration of chroline generation (I can't beleive I'm worring for this instead of extending the life of the CELL)
Thanks
10,000 gallon inground pool
Bookmarks