+ Reply to Thread
Results 1 to 10 of 66

Thread: starting up after winter

Hybrid View

  1. #1
    Join Date
    Jun 2011
    Location
    Oklahoma
    Posts
    46

    Default Re: starting up after winter

    I guessed on the cya since it was between readings . I added borax and bleach to shock level this am after getting test results. Thought I would test again this pm. I had thought the algae was dead but I think I may have lost some ground while we were gone. It is starting to look better but is still havin some grEen discoloration after brushing. I am still recirculating without the filter.

    Also I bought chlorine tablets to float in pool while we were gone. Ingredients say trichloro-s-triazinetrione 93.6% zinc sulfate monohydrate 3.5% other ingredients 2.9% available chlorine 84%. Are these ok to float in the pool?

    Also, it only turns greenish in some spots right when I brush but most of the water is cloudy /milky blue
    20' x 48" Intex round Ultra AGP ~8800 gallons -- Intex krystal clear 635t 1500gph; PF: 13

  2. #2
    Watermom's Avatar
    Watermom is offline SuperMod Emeritus Quark Inspector Watermom 4 stars Watermom 4 stars Watermom 4 stars Watermom 4 stars Watermom 4 stars Watermom 4 stars
    Join Date
    Dec 1969
    Location
    Charleston, WV
    Posts
    9,345

    Default Re: starting up after winter

    The tabs are ok except that your CYA is already high enough and those tabs add CYA. Go ahead and leave the ones in the floater that are already there, but then don't put anymore in. You can save the tabs to use for a short time if you go out of town again this summer or upon opening next year if you need to add some CYA.

    Keep your pool at shock level. Also, keep an eye on the pH since those tabs are acidic and will drive the pH down. Go ahead and put it on circulate.

  3. #3
    Join Date
    Jun 2011
    Location
    Oklahoma
    Posts
    46

    Default Re: starting up after winter

    Its starting to look a lot better after I stir. In fact I think the little discoloration I get is due to dirt. It quickly turns back into a cloudy/blue. Tests this am. Fc: 14.5, cc: 0.5, ph: 7.0. I see what you mean on the tabs driving the ph down cause I have been adding borax to keep it up and it keeps coming back down. I added more borax dissolved in hot water and the pucks are almost gone so hopefully that will solve this issue would it be okay to put the filter in at this point to try to clean this up? I have vacuumed a few times and gotten quite a bit of algae out. I cannot vaccuum to waste as imy vacuum is hooked up to my pump.
    20' x 48" Intex round Ultra AGP ~8800 gallons -- Intex krystal clear 635t 1500gph; PF: 13

+ Reply to Thread

Similar Threads

  1. Starting over
    By RedwingT in forum Intex-type Pool Setup & Operations
    Replies: 16
    Last Post: 08-02-2012, 12:54 PM
  2. Starting Over
    By shawnw in forum Pool Startup, Shutdown, & Winter Operation
    Replies: 5
    Last Post: 07-30-2012, 02:33 PM
  3. starting old pool
    By csc138 in forum Pool Startup, Shutdown, & Winter Operation
    Replies: 2
    Last Post: 06-26-2012, 02:44 PM
  4. Starting to get more confused
    By bjdrogo in forum Testing and Adjusting Pool Water Chemistry
    Replies: 8
    Last Post: 06-01-2006, 06:21 PM

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts