+ Reply to Thread
Page 4 of 4 FirstFirst ... 2 3 4
Results 31 to 32 of 32

Thread: cloudy water

  1. #31
    Join Date
    Apr 2012
    Location
    AL
    Age
    40
    Posts
    26

    Default Re: cloudy water

    Alright, I tested again this evening with my taylor kit. I guess my walmart kit was pretty spot on this morning. I just don't understand how the pH went from 7.3 to 8.0 by using 1 four pound box of borax? I checked twice to make sure I wasn't making some sort of mistake (pretty impossible to do that anyway). I'm really glad that I decided to only add that first box to see how it would affect it before adding the second box.

    So awhile ago the numbers were:

    FC - 1
    CC - 0.5
    pH - 8.0
    Alk - 100
    CYA - Didn't even bother wasting a test.

    I understand that most here recommend to run high pH levels regardless of what pools stores and Pool SOP's say but with it being at 8.0 should I adjust it down slightly to like 7.8? I also vacuumed to waste this evening and kind of took my time doing it which caused approximately 5 inches of water loss. It took right at 2 hours to get it back to proper levels so perhaps that might have knocked the pH down a tad by me adding all that water back??

    While at Leslies pool supply I picked up 8 pounds of conditioner (says 99% cyanuric acid and 1% other ingredients) per WaterMoms instructions I was going to add 5-6lbs of it and see where that takes the CYA to. Actually I think I might go with 4 lbs starting out to be safe. From reading here, just add straight into the skimmer and then don't backwash for 4 of 5 days so it will dissolve in the filter. Then do a CYA test and see where the pool is at. It is almost completely clear now but the deep end is still slightly hazy but still viewable on the bottom..

    Anyone see any problems with this plan?? Also I will still add a one or two bottles of 1.42 gallon bleach every evening.

    And that brings me to my last question…I actually have a lot more of these expensive tricolor 3" tablets than I thought. I understand they increase CYA so If I get my CYA to the proper level range, its probably best that I do not use these anymore right? If thats the case I've got a co-worker who swears by them and says its just about the only chemical he uses and says he goes through at least four 50lb buckets a year. I told him that I may sell him the rest of my bucket for a cheap price which is actually a 50lb bucket thats over 3/4 full. I thought it was a 25lb bucket and maybe I should keep 10 or so as a last resort like if I go vacation? I technically wouldn't need them anymore right? I wouldn't mind maybe making half of my money back on them.
    20K Gal Vinyl Liner IG Pool (16' Wide x 32' Long & 8' Max Depth)
    Hayward S244T Filter
    CL200 Feeder
    1.5HP Up-Rate Super Pump

  2. #32
    PoolDoc's Avatar
    PoolDoc is offline Administrator Quark Inspector PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars
    Join Date
    Jan 2005
    Location
    Georgia
    Posts
    11,386

    Default Re: cloudy water

    Hi Zac;

    My Hi pH page on PoolSolutions, basically says that you shouldn't fight your pH more than you have to, and that higher pH levels aren't necessarily a disaster. It does not say, "Thou shalt run a high pH", but it seems sometimes to be taken that way. Right now, you should try to stay between 7 and 8.

    Also, people tend to think all the test values are independent of each other. This too is not quite correct. Especially when you are cleaning up a swamp, all sort of things are going on that push the pH first one way, and then the other. If you had a chart with accurate test results and dosing actions listed every 4 hours, I might could tell you why your pH jumped, or maybe Chem_Geek could . . . but it's hardly worth it.

    Here's a simple fact: even when you follow the BBB method -- and used the fewest and simplest chemicals possible -- a pool's chemistry is MUCH too complex to fully model or comprehend. An analytical model of nothing more than the relationship between chlorine and stabilizer requires 14 equations -- and there are many relationships in pools besides that one. If you are working on a graduate degree in analytical chemistry, then it might be worthwhile to try to establish a comprehensive model of what's happening in your pool.

    But, if you just want to enjoy your pool -- or at least, not work yourself to death on it -- it would probably better just do respond to what's going on in your pool in the most direct and simplest method possible, and not worry too much about why it's happening that way.

    Regarding your trichlor . . . given that you have a high pH and a low CYA, I think this would be a good opportunity to use some of those tablets optimally: they will both chlorinate your pool, add CYA, and lower the pH, and you need all three functions! Unlike the trichlor, the granular CYA will keep indefinitely..
    Last edited by Watermom; 05-13-2012 at 08:47 AM. Reason: fix a typo to clarify

+ Reply to Thread

Similar Threads

  1. Cloudy Water
    By PoolConfusion in forum Dealing with Algae & Slime
    Replies: 3
    Last Post: 07-23-2012, 07:51 PM
  2. Cloudy Water
    By joserq in forum Pool Startup, Shutdown, & Winter Operation
    Replies: 19
    Last Post: 05-09-2012, 12:01 PM
  3. Cloudy Water
    By ComeShareACupofTea in forum Pool Chemicals & Pool Water Problems
    Replies: 7
    Last Post: 07-06-2011, 10:49 PM
  4. CLoudy Water
    By Sunshine427 in forum Pool Chemicals & Pool Water Problems
    Replies: 1
    Last Post: 06-01-2008, 02:57 PM
  5. Cloudy Water & Water Behind Liner
    By cschnurr in forum Dealing with Algae & Slime
    Replies: 0
    Last Post: 09-19-2007, 08:04 PM

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts