+ Reply to Thread
Results 1 to 8 of 8

Thread: High CYA and Persistent Algae

Hybrid View

  1. #1
    PoolDoc's Avatar
    PoolDoc is offline Administrator Quark Inspector PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars
    Join Date
    Jan 2005
    Location
    Georgia
    Posts
    11,386

    Default Re: High CYA and Persistent Algae

    Looks good to me . . . sorta.

    Your saturation index (pH + alk + ch) is out of sight. Once you're ready to close for winter, you may want to do something about that -- but it will mess up your pool for awhile when you do, so now's not the time. Just be careful to NOT add any alkalinity (baking soda) or calcium (calcium chloride). And do NOT let your pH go up: hold it below 7.4.

    Your chlorine is high enough, so that to get accurate pH readings, you'll need to mix pool water 50:50 with distilled (not: bottled!) water before testing. Make sure it's "distilled" -- usually available in the bottled water section at Walmart -- and NOT anything else.

    Also, keep your chlorine high and brush the pool out at least 1 cycle AFTER you think all the algae is gone. Then, and not before, you can let your chlorine drop.

  2. #2
    Join Date
    Aug 2011
    Posts
    4

    Default Re: High CYA and Persistent Algae

    First off, thanks for the continued advice. Just checking to see if I am following your instructions correctly.

    I held the FC=25 and PH=7.4 for a week and there were little to no signs of any algae. The past couple of days I've let it drop to 21 and now there were signs of algae growing on the walls. Should I just brush and raise it back up past 25 again for a bit longer?

  3. #3
    aylad's Avatar
    aylad is offline SuperMod Emeritus Burfle Ringer aylad 4 stars aylad 4 stars aylad 4 stars aylad 4 stars aylad 4 stars aylad 4 stars
    Join Date
    Dec 1969
    Location
    Northwest Lousiana
    Posts
    4,757

    Default Re: High CYA and Persistent Algae

    If you still have algae in the pool, then you need to raise it back up and hold it there, past the point where you think all the algae is gone. One good test for when to let it drop back down is when you can test at night after the sun is off the pool, and test again in the morning before the sun is on the pool, and see if you've lost chlorine overnight. If so, then you still have something in the water consuming it, so don't let it drift down yet.

    Are you also putting any brushes, poles, pool toys, etc. in the pool while it's being shocked, to keep from re-introducing algae when you use them?

    Might want to consider the use of Borates at 50 ppm, which acts as an algaecide and can be used in conjunction with regular shocking, HOWEVER, since Pooldoc has ponted out that you need to keep your pH low for now, I'll let him advise you on whether that might help in your situation.

    Janet

+ Reply to Thread

Similar Threads

  1. Persistent Mustard Algae
    By cherif in forum Dealing with Algae & Slime
    Replies: 0
    Last Post: 08-23-2012, 02:24 PM
  2. Having persistent algae problems?
    By Charlie_R in forum Dealing with Algae & Slime
    Replies: 0
    Last Post: 08-23-2012, 10:23 AM
  3. Advice Needed - High CYA, High Nitrates, and Lots of Algae
    By capshockeyfan in forum Pool Chemicals & Pool Water Problems
    Replies: 19
    Last Post: 07-03-2012, 05:47 PM
  4. Very Persistent Algae
    By chavez243 in forum Dealing with Algae & Slime
    Replies: 1
    Last Post: 06-24-2012, 04:55 PM
  5. Confessions of a newbie: dead algae, clarifier, persistent cloudy water
    By desertH2O in forum Dealing with Algae & Slime
    Replies: 1
    Last Post: 08-26-2010, 09:54 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts