OUCH! I hear what your saying. Don't have the facility to dump the pool without calling a septic company to come pump it so I'll go with the flow and see what happens. First thing tomorrow I'll take the heater offline. The chlorine level is still high due to the bleach fiasco but it is settling. I just tested the water and a few questions:

Readings:

Pool-
FC= 8-10 range ... off DPD chart but not to far (I did order the FAS kit)
TC= slightly higher maybe 10-12
PH= 7.2
TA= Only turned pale yellow - even after 30 drops
CYA= approx 120ppm

Checked fill water-
FC= .25
TC= .5
PH= 7.2
TA= 120ppm
CYA= 0

The 1" quick dissolving tabs I was using prior to switching to BBB were Trichloro-s-Triazinetrione= 99%

What would cause the TA test to turn pale yellow and never red?
It appears that the pool water can't absorb anymore Borax as there is a small amount of residual on the pool floor picked up by my Rover - should I continue to keep the PH up with it?
Would it make sense to dump say 30-50% of the water or is it all or none?
Lastly - how do I change my profile, it says I can't access?

Thank you all for the help - even if it's bad news. If nothing else it is a lesson learned for the future.