I just installed a Salt Generator and a new Intelliflow pump with 4 speeds. I'd like to be able to run my pump at the two lowest speeds but there isn't enough water flow to fully cover the plates in the salt generator. This causes the salt generator to shut down. I was wondering if I can plumb out the generator in a different manner to keep the plates submerged or buy something that will purge the air out of the canister. Right now the canister is mounted horizontally. The water flows in from the bottom and then leaves the bottom of the canister. I was thinking of plumbing it so the canister has the inlet and outlet are at the top and not the bottom.

Here is a picture of a similiar setup. The air is being trapped at the top of the canister. I have mine plumbed with two" pipe. Any advice is appreciated.