Metal Free or Not

[PoolDoc]

Again, it's not likely that your pH hasn't changed. What is possible is that your pH is so low that your existing test kit can't measure the change.

Do this:

#1 - Do a pH test again. Presumably, it will turn yellow, which with phenol red is 6.5 or LOWER. Add a tiny pinch of borax to the test chamber. The water should turn purple or at least red. That verifies that everything is working.
#2 - Add around 23 more pounds of borax - 5 boxes of 20 Mule Team borax -- which may or may not raise your pH enough, but will put you firmly in the 'good zone' for borates.
#3 - Retest. If your pH is STILL not high enough, buy some Arm and Hammer WASHING soda (not baking soda). Here, locally, it's right next to the borax in Walmart. Add 2 boxes at a time, wait 2 hours, and retest. Drop back to 1/2 box at the first sign of pH change.

(Follow Waterbear's advice on the Metal Free)

[Firecat]

Tomorrow I will go out and try to hunt down some Borax, 2 Meijers and 1 Walmart are out by me.

I did pick up some washing soda though, can I just use that instead of the Borax? Or is there a reason to use the Borax?

I did get my water test kit today and tried it out, looks like your recommendation for the amount of Borax is about spot on.

Just need to get the PH up to stop the chlorine from burning out at a rediculous rate.

[Watermom]

Reread post #13 point #3. Ben tells you there to use Washing Soda. Good to hear that you got your kit! That will make this a lot easier for you. BTW -- the pH has nothing to do with the chlorine consumption.

Keep us posted how you things are going!

[Firecat]

Ok, I did not know to use the washing soda in place of the borax but I did find 4 boxes today so when that runs out I will continue with the washing soda. I thought I had read that PH stabilizes the chlorine so it does not fade out so fast, I am learning and open minded so please teach me the correct ways.

Thanks alot.

-Jay