had pool for a few years

[airraid1999]

just changed liner and starting all over water is full pump running water clear and just cant get stabilizer up and pool to hold clorine i am new to site and new to BBB method have used pool shock and 3" puck s along with the usual stuff sold at pool place help in start the BBB METHOD

[PoolDoc]

Shouldn't be too hard:

#1 - add 1/2 gallon of 6% chlorine bleach per 10,000 gallons of pool water . . . EACH evening till you've gotten stabilizer up.
#2 - add 3 - 5 lbs of stabilizer to the pool per 10,000 gallons. Do so by FIRST cleaning your filter and then SECOND by adding the stabilizer slowly to a skimmer. Leave the pump running 24/7 for the next 4 days.
#3 - buy a cheap OTO / phenol red test kit (Walmart or wherever) and start testing each evening b4 you add chlorine. Don't add chlorine if the OTO is very dark yellow or orange.
#4 - report your results back here, and we'll help you move on to the next step.

Ben

[Watermom]

And, to add to what Ben wrote, seek advice here before buying/adding "the usual stuff from the pool store." Pool stores are notorious for selling you a bunch of stuff you don't need.

One last thing he forgot to advise ------- go swimming and enjoy your pool! Welcome to the forum!

[airraid1999]

just check pool with test strips i know get a kit i have used strips the whole time anyway i still read all ok except stabilizer and to 1st reply i added 4 lb of stablizer 2 days agog and pump been riunning continnuosly since water was full about a week i have a round 21ft x52" pool over last seasons no trouble at all but i changed liner and in so had a complete water change that is why i started all over so what is oto and what can be used to bring up stabilizer also i started this year using a dispenser instead of putting pucks in skimmer ? oh and forgot and most important i also changed sand will be looking for reply thanks lots

[Watermom]

I'm guessing that your volume is around 10K. 4 lbs of stabilzer in a 10K pool should add about 50ppm of stabilizer. It takes up to a week to totally dissolve and give you an accurate reading so don't test it for awhile. You really don't want your stabilizer (cya) level to be any higher than 50, so I would not recommend using those pucks. They are Trichlor pucks and they add more stabilizer which you don't need. I would suggest just using bleach as your source of chlorine for this pool.

[airraid1999]

thanks and its around 12,000 gallons also i am going to get a test kit , plz for give my typing as dont work on pc for living nor daily any how i found this site by serching best way to hold down steps, what is OTO? the clorine has been haed to get where it needs to be i dont know why as it may be due to rainfall ? we have had lots! i didnt have this much trouble the last 4 years together???? just wonder what i am doing wrong then when i came across this site and read about pool places and read the BBB method it goes aginst what the pool place says not to use bleach not to use baking soda and ect but as i ahve read you guys have been at this a long time so? any way thats my story will be asking more questions as i go using the BBB AS IT LOOKS AS IF IT WORKS FINE BY THE WAY THE STORE I USE NAME IS POOL SOLUTIONS???? THATS FUNNY THANKS AGAIN