If you haven't added any stabilizer, go ahead.
Also, add a box of borax a day, till your pH is above 7. (Low readings of pH, with highish chlorine are more likely to be right than high ones.)
Ben
If you haven't added any stabilizer, go ahead.
Also, add a box of borax a day, till your pH is above 7. (Low readings of pH, with highish chlorine are more likely to be right than high ones.)
Ben
PoolDoc / Ben
FYI -- the reason Ben suggested you use Borax to raise pH instead of soda ash is that soda ash affects pH and alk whereas, Borax will mostly affect pH and your alk is fine where it is.
Thanks! I added a box of borax and 40oz of stabilizer. Tested the Ph and it didn't move (still below the testing kit colors) from 6.6 or lower. Can I add more Borax or should I wait till the morning?
I would wait until there's been about 4 hours since your last Borax addition. Retest for pH, and if it's still less than 7.0, add another box, slowly. Looks like your pH is much lower than what the test can register, so it can take quite a few boxes of Borax to get back where you need to be.
Janet
Janet
Retested this morning. Cl 12, Ph 6.6 or lower, CYA 30. Added another box of Borax as the first box didn't seem to do anything. The label on the stabilizer said to adjust your Ph to the correct level before adding. I already had added 42oz to get my CYA level to 40. I was going to just wait a while before adding anymore stabilizer to see if it will continue to rise. Once again, we were hit with a lot of thunderstorms that dropped a lot more rain. Any suggestions?
Thanks again for all of your help!
Don't add any more stabilizer at this point. Keep adding Borax a box at a time until the pH starts to move. Wait a couple of hours, retest and redose. You need to get that pH above 7.0 ASAP.
ok.
ph is now 7.4 and Cl is 5.0. The pump has been running 24/7. Should I stop running it for so long and turn on the SWG?
Thanks!
Latest test results: Cl 3.0, Ph 7.6, Al 70 and CYA is at 35. Pool is crystal clear. I turned the pump down to about 6 hours and turned the SWG to 15%? What should I do next? Add CYA, baking soda? Thanks again for all of the help!
Bookmarks