Quote Originally Posted by SoCalBoo
Pat,

Unplug the trisensor...is that the plug that goes into the cell?

Aeration - look at FAQ sticky under Alkalinity Subtopic

Solar Panels - I was thinking that some water with the bleach should be circulated up there to make sure that algae/'goo' up there gets some...is the 6 hours or so that it is hot enough for the thermostate to open the solar valve enough?

Thanks
The trisensor cable is the other one going to the tri-sensor plug before the cell.

Ok. I read the section on aeration with acid, and it is for lowering TA mainly although it will lower pH. If your TA levels are fine, then don't aerate.

There should be no need to run through the solar panels as they are after the filter. When the system is shut down, the panels should drain back to the pool.

Hope this helps.

Pat