Poolsean: I will direct this question to you but wanted to post it in the forum in case someone else comes along with the same or related question.
We bought our house about 2 months ago and had a new liner installed in the IG pool. I purchased a Pool Pilot Digital w/ the SC-48 cell. I have approximately 22k gallons of water and have the salt level at 3200ppm according to the Pool Pilot (hasn't been calibrated against a salt water test though, should I?). The system ran for 24/7 for a few days until my water was crystal clear. Now I have it running split 4hrs during the day and 4hrs during the night for the past 1.5 weeks. Everything "looks" good and I say this because I only have guess strips to test with as of yesterday. My K-2006 Taylor kit is due in today so I can get some more accurate numbers.
Now for the question:
1) What is the correct power level for my system? The manual is very unclear in this area.
BTW, my water temp is hovering in the low to mid 90s right now (bath water) if it matters.
2) Can I control a variable speed pump or just a two speed with the digital system?
3) Related to 2, will the system just swap between low and high speed (for a two speed pump) or can it switch between low, high and off?

Thanks,
Michael