Who has an Intex Ultra Frame 24' pool?

[jkoch]

I am getting ready to set up a new Intex Ultra Frame 24' pool. What I am looking for and Intex can't provide me is the footprint drawing of where the support poles land.

I want to put footing under each pole and need to have them installed and level prior to setting up the pool.

Can someone with a 24' Intex Ultra Frame Pool Help? Just some simple dimensions would help me a bunch. I would be very greatful.

Thanks

[Watermom]

Did you buy the pool locally? If so, do you think maybe the pool store would be willing to call another customer who previously bought this pool to see if they would mind if you drove over and took a look?

[jkoch]

Good Idea but its a Wally World pool and their less help then Intex.
Thanks

[moose364]

its very hard to say for sure where they will end up at. I know that might be hard to understand, but untill you have the pool together then you will. the pool flex's alot, and with the flex the legs move. mine is pretty level, I think Im off 1" and that was from using a string level, get a laser level to level it up. you can find cheap one's on ebay for around $25. back to the legs, I did the same as you and wanted to set them on pads and did but after filling they slid almost all the way off in places, I used the 6x12 pads, so if I was doing it again, I would use the 12x12 pads and hope when the pool filled the legs would still be on the pads. to me that your best shot, some of my legs or stright, some lean a little in, some lean a little out, and if your standing on the outside of the pool when everybody is jumping and playing it will scare you to death how much this pool moves around, don't get me wrong. its been an awesome pool, I upgraded the filter to a sand dollar 1hp sand filter, which was the best thing I done, we are in our second year with this pool, next year we are going to upgrade to a 24'hardside above ground,
If I can help in anyway, let me know

[jkoch]

Thanks a bunch. I can use 12" by 12" pads for sure.

How did you know what the diameter of the circle was where the pads land?
It says its 24' pool but that is probably not where the legs are.
Thank you

[moose364]

The way we done it was to level off a 24' dia spot, then put the pool together, then level all the legs, this is where the laser level will come in handy, your going to need a couple of guys to help you put it together, the last piece of top rail is a #$%@$#$ to get in, then you can put a little water in, maybe 2" then go back and level the legs. its a pain in you know where, but that is the best way I could figure it out, like I said the legs move they slid out as you add water, and when everyone i the pool they still move a little.