I let it go last year after I couldnt find a 1/4" to 1.5" adapter but this year i may need to move forward and find a solution to this.
So waste, you are recommending cutting the old pipe off if I cant "unscrew" the gauge and putting a new pipe in place that I can "tap" into.
I'm a little worried about tapping into a pipe with such a high pressure area and I dont want the gauge blowing off one day. Any more tips on how to get this done?
The old owner glued a 1.5" pvc elbow into the old EC65 gauge "hole" and extended the pvc to run sort of parallel to the filter. I was thinking of cutting the pvc right below the existing gauge and installing a new gauge at this location. Any additional tips are much appreciated.
Bookmarks