Aqua Green in color

[aylad]

The bleach will sanitize the water, and help do away with the Pristine chems, but the filter is what removes it from the water.

Janet

[Dirtboy6]

First of all let me say THANKS everyone for the help. Asking my local pool stores for help is a joke all they want is your money. I took todays water sample by they did not give me a sheet just told me what to buy. I told them no way!! I understand I need stabilizer but then he told me I can help you out if you buy from me arrrrrrr. Also he could not test my CYA they were out he said. Anyway this is all I have for today



PH - 8.0
TC - 2
TA - 200

I added 4.26 gallons of bleach yesterday. Tc went from 0 to 2 Ta also went up as far as CYA It will be 7 or lower so I will get the stabilize to put in. In a 26,000 pool what would be a good lb for the stabilizer.

Once again

Thanks

[polyvue]

First of all let me say THANKS everyone for the help. Asking my local pool stores for help is a joke all they want is your money. I took todays water sample by they did not give me a sheet just told me what to buy. I told them no way!! I understand I need stabilizer but then he told me I can help you out if you buy from me arrrrrrr. Also he could not test my CYA they were out he said. Anyway this is all I have for today

PH - 8.0
TC - 2
TA - 200

I added 4.26 gallons of bleach yesterday. Tc went from 0 to 2 Ta also went up as far as CYA It will be 7 or lower so I will get the stabilize to put in. In a 26,000 pool what would be a good lb for the stabilizer.

Have you discovered The Pool Calculator yet? It's a pretty nifty application. One of its functions allows you to enter your current chemistry levels, number of gallons in your pool etc and then advises on the approximate amount (number of ounces, cups, pints or gallons) needed of the chemical you're trying to increase.

[Dirtboy6]

Thanks! will check it out

If I add muriatic acid how long do I need to wait till I add stabilizer?

[Watermom]

Probably 2 or 3 hours would be fine. How are you planning to add the stabilizer? Most people think it dissolves fastest if you put it in an old sock and hang it in front of a return jet.

[Dirtboy6]

Thought about the tube sock. What would be the best way to tie it off from the side. If I don't go with the sock should I slowly add it to the skimmer?

[Watermom]

Yes, but if you do put it in the skimmer, you must leave your pump running and not backwash for up to a week. CYA dissolves really slowly (takes up to a week) and if you backwash before then, you'll just throw it out. Also, don't retest for it for a week so you won't accidently get too much in there.

Having said that, before you add it, can you give a current set of water testing results -- everything. Also, how does the water look now?