+ Reply to Thread
Results 1 to 9 of 9

Thread: Pump Electric Advice

Hybrid View

  1. #1
    Poconos is offline SuperMod Emeritus Whizbang Spinner Poconos 4 stars Poconos 4 stars Poconos 4 stars Poconos 4 stars Poconos 4 stars Poconos 4 stars
    Join Date
    Dec 1969
    Location
    Honesdale PA
    Posts
    1,812

    Default Re: Pump Electric Advice

    I saw this post last night and wanted to think a little. This stuff is confusing to me to but here is my best thoughts. FLA Full Load Amps I think means just that. With the motor (no pump attached) loaded to it's maximum rating that will be the current draw. Now, when the motor is hooked to a pump and moving water is the motor putting out its max power? No. What is the real load? Depends on how much water you're moving which is the amount of work being done. I think the 16.4 part of the info is what I said. It makes sense the 4.4 is the low speed amps.

    Now this stuff I do know and is back to basic electricity. From copper wire tables at 77 deg F. a 100' 12 gauge cord will have a resistance of 0.324 ohms. (#12 copper is 1.62 ohms per 1000 feet and you have 200 feet of wire). At 16.4 amps that is a 5.3 volt drop. Fairly significant. Starting current will be a lot higher momentarily. The 15 amp breaker will probably get warm so you should consider going to a lower resistance line and a higher rating on the breaker.

    Hope this helps.
    Al
    16'x32' oval 22K gal IG vinyl pool; ; Hayward S244T sand filter; Hayward superpump 1 HP pump; hrs; K-2006; PF:5.5

  2. #2
    Join Date
    May 2010
    Location
    Arizona
    Posts
    255

    Default Re: Pump Electric Advice

    Since your original circuit has a 15 amp breaker, I can only assume that this circuit is using 14 gauge wire, but you didn't mention how far this circuit run is from the breaker panel to the outlet where the extension cord is plugged in, or if there are other outlets on this same circuit. In all likelihood, you could have a slight amount of voltage drop before you ever get to the extension cord. Like Al said your bigger motor may require a bigger circuit. You might want to consider installing a complete new circuit with the proper rating for your new motor.
    Last edited by BigTallGuy; 06-14-2010 at 10:23 AM.
    If you can afford a swimming pool and computer, you can probably afford to help keep the PoolForum alive. Please be a responsible member and subscribe today. You'll probably save more than the membership fee on your first trip to the pool store. BTG

  3. #3
    pratzert is offline Lifetime Member Thread Analyst pratzert 0
    Join Date
    Dec 1969
    Location
    .
    Posts
    58

    Default Re: Pump Electric Advice

    Thanks for all the info.

    It sounds like I would be better off returning this pump and getting a 1HP with a lower AMP use rating.

    It would avoid all these problems and having to add another outlet with a new 20AMP breaker.

    Just ain't worth it. Back to Namco it goes.

  4. #4
    Poconos is offline SuperMod Emeritus Whizbang Spinner Poconos 4 stars Poconos 4 stars Poconos 4 stars Poconos 4 stars Poconos 4 stars Poconos 4 stars
    Join Date
    Dec 1969
    Location
    Honesdale PA
    Posts
    1,812

    Default Re: Pump Electric Advice

    With the smaller pump you'll be happier every month too.....when the electric bill comes.
    Al
    16'x32' oval 22K gal IG vinyl pool; ; Hayward S244T sand filter; Hayward superpump 1 HP pump; hrs; K-2006; PF:5.5

  5. #5
    pratzert is offline Lifetime Member Thread Analyst pratzert 0
    Join Date
    Dec 1969
    Location
    .
    Posts
    58

    Default Re: Pump Electric Advice

    Quote Originally Posted by Poconos View Post
    With the smaller pump you'll be happier every month too.....when the electric bill comes.
    Al
    No arguement there !

    Thanks.

+ Reply to Thread

Similar Threads

  1. DIY electrical wiring for the pool
    By celery1977 in forum Pool Equipment & Operations
    Replies: 2
    Last Post: 07-01-2013, 07:49 PM
  2. Advice Needed on Electric Cover
    By bbroglio in forum Pool Equipment & Operations
    Replies: 3
    Last Post: 09-08-2007, 04:45 AM
  3. Old Pool Pump--high electric bill
    By Metolius in forum Pool Equipment & Operations
    Replies: 0
    Last Post: 07-06-2006, 12:26 PM
  4. gas vs. electric heater?
    By rlp in forum Pool Equipment & Operations
    Replies: 27
    Last Post: 04-14-2006, 08:41 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts