Will be a new pool owner shortly, just purchased an 18' AGP that will just fit in the flat section in our yard. I need some assistance\information for wiring an outlet for the pump.
The pool store stated I needed to wire for a 15 amp breaker. Is this sufficient or would a 20 amp breaker be better? Will I need a GFCI breaker or are twistlock outlets available as GFCI?
What type of wire is best to run in conduit? Does everyone have a switch, timer or both? I also need to bond the pool (wire from the pump housing to the pool?)

The pump will be a 1 hp pump with a 100 pound sand filter. The total run from the box will be about 50'-60'. Our local code stated the outlet must not be within 5' of the water.


I already have a conveinence outlet underneath our deck. I have wired runs for outlets, lights, etc. in our home so I have the basic knowledge required. Would I be better off attempting a DYI or calling an electrician (anyone have an idea what the wiring install would cost)?

Thanks in advance for your help!

Ben