pool store ethics?

[henssguitars]

thanks, I think I may need more liquid cl before monday when the pool store opens, can I use the liquid bleach in the meantime if needed?
just tested after adding 3 gallons of liquid cl no trace of cl, I must have lots of baq junk in the pool that the cl is attacking.
I added 4 more gallons and will test in an hour or so.
Again I am very greatfull for everybodys help, it makes this a lot less stressfull.
Thanks,

Bill

[aylad]

Bleach is the same thing as liquid chlorine, just don't get the stuff that's scented or with extra additives. Pool store liquid chlorine is 12.5 %, regular bleach is 5.25%, and ultra is 6%. I use the generic bleach from WalMart almost exclusively in my pool.

Janet

[henssguitars]

thanks again!
I am going through cl like it is going out of style!
after adding a total of 18 gallons of 12.5 I still can't get a reading above 1.5 fc with the test kit.
I hope I am reading it right, I will certainly run to wall mart in the a.m to fill my pick up full of bleach.
I know my baq oxidizer level was high when I started, so I am sure that is the culprit.
The water turns deep brown right after I add the cl, than fades to light green.
I have back washed several times and will keep testing every hour, adding cl until I go to bed.
Hope this is the proper procedure.

[CarlD]

Unless your pressure is rising and the force at your return falling, don't bother backwashing. I don't think you need to test more than 3x/day.

But you're going to use a lot of chlorine!

[Watermom]

Don't forget to take pictures along the way.

[henssguitars]

Hi all ~ this is Bill's wife...thanks so much for all your help so far. Bill has splashed CL in his eye so I'm doing the typing

We have been taking pictures...our neighbors thought our pool was filled with chocolate milk. Very funny!

So far we have added 18 gallons of 12.5% liquid CL. We just took a reading that indicated 3 FC. Our test kit only goes to 5 FC. How do I know when FC levels are at the recommended 15ppm with our test kit? I'm worried we are going to add too much too fast.

Thanks again for all of you input ....we would be lost without you!

[Watermom]

You can use a dilution method to make your test kit read higher. It does lose accuracy but will at least give you a ballpark figure. Take one part pool water and an equal part distilled water. Mix, pour some into the test vial. Then, multiply the result by 2. If that doesn't go as high as you need, take one part pool water and two parts distilled water, then multiply results by 3, etc.

Hope Bill's eye is ok.