Low calcium hardness in vinyl pool ok?

[maryberrye]

Since I have a vinyl pool, I've taken Carl's advice and never bothered with the CH test. I am curious though what Ben's idea of a too high calcium reading is? We live in an area with very hard water - 469 ppm. Is this too high?

Thanks,
Mary

16k IG vinyl
FC 4.0
CC 0
PH 7.5
CYA 29
ALK 240 (working on it now)
temp 80

[CarlD]

If your CH is close to 500ppm and your T/A is 240ppm, you are in danger of your pool going very milky. It will be safe, but not too pretty.

Get your T/A down to at least 100, or even 80 and you should be OK. But don't add anything with calcium, ever!

[aylad]

The problem with high calcium in a vinyl pool is that it can make the water very milky, especially after being shocked. In an area where your fill water is very high in calcium, then you need to try to keep your alk and pH on the lower ends of the normal range, especially if your water looks cloudy and won't clear with shocking.

Janet

Edit: Carl beat me to it this time!

[Watermom]

No cal-hypo for you! By the way -- maryberrye --- welcome back to the forum for another swim season!

[maryberrye]

I've never been able to get my TA down below 180. I am faithfully adding small amounts of muriatic acid (diluted in a bucket of water before it goes into the pool) to lower the PH to 7.0 then bubbling the heck out of it with the air compressor bubbler my husband juryrigged for me on Saturday. All the while keeping my pump running. The water was very milky yesterday but I shocked it, and it's clear(ish) now. At 180 TA we get very clear water if everything else is properly maintained. I doubt if I will ever get my TA as low as 80-100, I'm not that patient. And, not to worry, I have avoided adding anything to do with calcium for the last five years, since you all have reaffirmed it's not necessary, I can't imagine wanting to start now

Thanks all for the welcome backs!

Mary