+ Reply to Thread
Page 1 of 2 1 2 LastLast
Results 1 to 10 of 13

Thread: How to find a hole in the liner?

  1. #1
    Join Date
    Dec 2004
    Location
    Cleveland, OH
    Age
    49
    Posts
    121

    Default How to find a hole in the liner?

    I have a small hole somewhere in my liner. It must be very small as I lose water very slowly. Is there any way to find the hole in the liner without replacing it?

  2. #2
    waste is offline PF Support Team Whizbang Spinner waste 3 stars waste 3 stars waste 3 stars
    Join Date
    Dec 1969
    Location
    S.E Maine
    Age
    58
    Posts
    1,765

    Red face Re: How to find a hole in the liner?

    There are ways, I'm having to borrow a computer since mine is unusable right now You can use dye to check any suspect areas, if the dye gets sucked in, you've found the leak.

    However, I'd double check the filter system first, especially a backwash line leak or something at the pump or filter!

    I know others here can help, but it will be a few days before I can get my computer back on line (if I can ) and find the info I've written on this - I'll check in as I can, but feel 'handicapped' by not having my computer.
    Luv & Luk, Ted

    Having done construction and service for 4 pool companies in 4 states starting in 1988, what I know about pools could fill a couple of books - what I don't know could fill libraries

  3. #3
    b2001 is offline Registered+ Thread Analyst b2001 0
    Join Date
    Dec 2004
    Location
    Dallas, Tx
    Posts
    94

    Default Re: How to find a hole in the liner?

    My neighbor has gone through two incidents of leaks in his liner. The first time, he could never find it; had to replace the entire liner.

    He had the same issue this summer - losing several inches of water every day. He hired a pool leak service provider. I don't know the specifics, but something similiar to the following equipment was used:

    http://www.leaktools.com/mm5/merchan...egory_Code=VLD

    My understanding is that a continuous connection to ground is established where ever there is a hole and the operator can hear it and zero in on the leak through sound and headphones. In my neighbor's case, there were about 8 different holes; the operator also found a couple that were real close.

    I believe that my neighbor paid $200 to $300 for the locating of and patching of the leaks - a lot better alternative than replacing the liner.

    You might check into this in your area.

  4. #4
    Join Date
    Dec 1969
    Location
    .
    Posts
    30

    Default Re: How to find a hole in the liner?

    My daughter discovered that if you lay swimming goggles on the surface of the water it magnifies the bottom of the pool. She walked around looking at the bottom and sure enough she found a small slice in the bottom about 1/4" an inch long. we patched it and the water leak slowed down so she started looking again and found two more. No more leaks and to think I was going to replace the liner.

    vanman2501

  5. #5
    Watermom's Avatar
    Watermom is offline SuperMod Emeritus Quark Inspector Watermom 4 stars Watermom 4 stars Watermom 4 stars Watermom 4 stars Watermom 4 stars Watermom 4 stars
    Join Date
    Dec 1969
    Location
    Charleston, WV
    Posts
    9,345

  6. #6
    Join Date
    May 2010
    Posts
    20

    Default Re: How to find a hole in the liner?

    Is this an above ground pool?
    Do you see any wet spots on the ground?

  7. #7
    waste is offline PF Support Team Whizbang Spinner waste 3 stars waste 3 stars waste 3 stars
    Join Date
    Dec 1969
    Location
    S.E Maine
    Age
    58
    Posts
    1,765

    Default Re: How to find a hole in the liner?

    Ag pools will show their leaks if the leak is on the wall or close to the wall.

    If your AG has a hole on the bottom of the liner, it's doubtful that you would be able to see the water puddling

    If the leak is small, it's harder to find, but - once found, a patch can give you ~5 more years of use

    If you have any questions about patching the liner or finding the leak - all you have to do is let us know
    Luv & Luk, Ted

    Having done construction and service for 4 pool companies in 4 states starting in 1988, what I know about pools could fill a couple of books - what I don't know could fill libraries

  8. #8
    Join Date
    Jul 2011
    Location
    Huntsville, AL
    Posts
    13

    Default How to repair an IG liner leak at the skimmer interface and replace skimmer

    I have a 7 yr old liner( in a 40 yr old pool) that is leaking at the liner to skimmer faceplate gasket (the pool framing is steel). In addition I have a cracked skimmer that requires replacement. I do not want to replace the liner. The 3.5" concrete deck will be cut away to access the skimmer area and most likely dirt base to dig up to remove and replace skimmer and new faceplate & gaskets. The new faceplate & skimmer match identically the old. My questions are twofold- (1) while the liner is quite pliable what risk do I run of the liner being torn during disassemble of faceplate and gasket and what could be done to patch it? ( I have had a couple of pool companies come and look at it and they say "no problem"-However in their wriiten bid they claim no responsibility if they tear the liner!! (I find this hard to take!!). (2)- What's your opinion that the liner leak may have rusted badly enough to require patch of the steel and would the liner need to be replace to make the fix?

    Thanks for your help

    Ralph

  9. #9
    aylad's Avatar
    aylad is offline SuperMod Emeritus Burfle Ringer aylad 4 stars aylad 4 stars aylad 4 stars aylad 4 stars aylad 4 stars aylad 4 stars
    Join Date
    Dec 1969
    Location
    Northwest Lousiana
    Posts
    4,757

    Default Re: How to repair an IG liner leak at the skimmer interface and replace skimmer

    Ralph,

    This sticky is meant for how to find holes in the liner. You have a specific situation that you need advice for...therefore, I've split this post off into its own thread in this forum, here http://www.poolforum.com/pf2/showthr...eplace-skimmer. For those offering advice, please reply to the new thread.

    Thanks!!
    Janet

  10. #10
    Join Date
    Jun 2010
    Posts
    10

    Default Re: How to repair an IG liner leak at the skimmer interface and replace skimmer

    I swim around with goggles and look, I have found everyone of my holes.

+ Reply to Thread

Similar Threads

  1. Hole in liner, again!
    By TC CPT in forum In-Ground Pool Construction and Repair
    Replies: 3
    Last Post: 05-26-2008, 02:06 PM
  2. Hole in Liner
    By spcchap in forum Pool Startup, Shutdown, & Winter Operation
    Replies: 8
    Last Post: 11-13-2007, 01:31 PM
  3. hole in liner
    By tara15 in forum In-Ground Pool Construction and Repair
    Replies: 3
    Last Post: 05-22-2007, 08:51 AM
  4. Huge Hole In Bottom Of Liner Pool
    By bkny1055 in forum In-Ground Pool Construction and Repair
    Replies: 10
    Last Post: 09-07-2006, 02:19 PM
  5. Finding a hole in liner
    By Joe44 in forum In-Ground Pool Construction and Repair
    Replies: 8
    Last Post: 08-17-2006, 05:58 PM

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts