Ascorbic treatment

[waterbear]

A couple of observations:
first copper usually does not react well to ascorbic acid, especially the BROWN copper stains (the blue ones might but the bronw, grey and black usually won't).
second, you said you are on well water. Have you tested it for iron? I suspect that you have iron staining from your well!
I also suspect that the reason your copper levels are so high are linked to your use of trichlor.
first, is your clorinator before of after your heater? It should be after. If it is before it explains the high copper levels.
If it is after it means you have not been keeping tabs on your TA and pH because the only reason so much copper would dissolve is because your water was too acidic. This is fairly common with trichlor use.

Finally, even forgetting that your CYA is way too high YOU NEED TO DRAIN THAT POOL AND REFILL BECAUSE YOU HAVE 5 PPM COPPER IN THE WATER. THAT IS WAY TOO HIGH TO BE SWIMMING IN AND IT IS NOT HEALTHY. COPPER IS TOXIC, THAT IS WHY IT IS USED AS AN AGACIDE AND YOU HAVE ABOUT 16 TIMES THE ALGAESTATIC LEVEL IN YOUR WATER!!!
ANYTHING ABOUT 1 PPM IS TOO HIGH!

sorry for shouting but you really need to pay attention to that.
bite the bullet, drain and refill and treat your well water for the iron that I suspect actually caused your staining.

[essikr]

Thanks for the reply I will answer as best as I can.

I don't use the raw well water to make any adds,have an iron remover on the water system if I need to add. We are in Ohio and it seems we get enough rain to keep the pool level up. My winter cover is the safety type that lets water in.Usually have to put water out several times before pool open.
The chlorinator feeds after the heater.Sounds like I need to use only bleach.

The ascorbic acid removed the stain pretty quick.
I don't have a way to test for iron or copper .
Had it tested at two different stores ,one said the copper was 5, the other didn't list any. They may not have tested for it.
I beleived the stain was from iron when first detected and didn't put much trust in the test that said it was copper.
As an added note ,we live within a 1/2 mile of an operating steel mill.Though they have a dust collector system I'm sure we receive some pollution.We see the brown stain on some of our vinyl siding. Idea!! I never tried to take the stain off with Ascorbic acid. I will try it .
Looks like I need a test kit for metals? Need some advice on that.
Finally I would like to avoid a complete drain at this time. We had planned to replace our 18 year old liner in the fall.

[mbar]

eeek, I missed the 5 copper Waterbear is right, drain and refill. You may have other metals in your fill water, but they can be controlled with sequestering agent. You have to check the trichlor - a lot of it has copper in it now - it is used as an algaecide. Also with the trichlor it makes the water very acidic which can eat the copper element in a pool heater. Brown stains are ususally iron, which is very common in well water.

[mbar]

I was replying while you were typing It does sound like you may be getting the metals through the air. It does sound like iron. I think you will have to use a lot of sequestering agent - putting some in every week to maintain what is lost through backwashing and dilution. Is there a municipal water testing place you can take your water to? It can give you a more detailed list of what metals are in the water. I wouldn't trust a pool store that said you had a copper level of 5 and didn't say anything to you. You can live with a little staining, but a copper level of 5 would not be advised. If you are going to get one more year out of your liner, then just use the sequestering agent, and keep up with the stain with a little ascorbic acid every now and then. Just be sure to check out the copper. You also must keep an eye on the ph - ascorbic acid will lower the ph too.

[essikr]

Happy Fathers to all you Dads and to Moms that take Dads place!

Well I put some vit C tablets in a sock and tried it on the house vinyl siding, it removed 90% of the stain.I then wiped ( just a light rub) the pool step it removed the stain 100%anf the steo was pure white. Brushing and rubbing with a rag did nothing to the stain. I will follow all of your suggestions and keep a better eye on the water chemistry.
One question when I used my new K -2006 the FC=.8 CC=.2.
When I checked it with my old HTH delux test kit the TC= 8-10. Using my old kit I kept the level between at 5-8. This looks like it was misleading me to believe my level was good.

Still think it is iron and not copper!!!

[waterbear]

I have no doubts that your stains are caused by iron. Ascorbic acid would not remove brown copper stains at all!
Still get a recomfirmation on the copper levels in your water. For this you can use a copper test strip or even an aquarium copper test as long as it will register in the range of 0 to 1 ppm. If your copper is 1 ppm or above bit the bullet and drain.

[essikr]

Hello again !
Hope I'm not being a pest! Several things discovered today may be of interest to other pool owners.
The eyebolts that the safety rope attaches to were chrome plated .The chrome eventually has worn off leaving the base metal . The base metal is brass . I can see some corrosion on them (I removed them today). just wondering if this is the source of the metal in the water. Brass is a mixture of copper and zink. I realize the water balance is still the cause to erode the chrome off the eyes and then attack the brass. mwb
On another note , the step that I cleaned this morning with Vit C is starting to stain again this afternoon.
At this time it's a nice sunny day and my daughter is coming over. The ribs are on the grill and I'm on my third margarita. This father is going in the pool!

[szampino]

Essikr,

Hope you had a great Father's day. I would suggest you consider Waterbear's post and confirm/deny the copper level in your water before you take any additional actions including more swimming.

re: the staining. Given your CYA level you may have a very hard time controlling your Metals even with the Sequestering Agent.

I would reccomend that you post another complete set of numbers including your current CYA level.

[essikr]

It took awhile but I got a copper test kit these are the numbers on the water today.

CC=.2 FC =4 PH=7.3 Alk= 110 Cal hd=150 CYA = 110 copper .8

The stain is back as bad as it was when I started.I appreciate the suggection offered. Since our summer abruptly ended,no one is swimming in the pool. I found another source for ascorbic acid at Essential wholesale and ordered 5 pounds. Is there any way to determine how much sequestor I need to use when I do another ascorbic treatment?