Hope you're there Marie ??

[stma]

I'm just hoping this will not be a continual problem going forward.....I've never (in the past 8 seasons) had an issue with metals.....

N'Joy the Va-K

[szampino]

Posting reply here.

Regarding the Chlorine level for Metal control, I suggest you keep it low and your PH low. The Metal Control typically suggests a 7.0 PH, I have also read that keeping the Chlorine low is helpful.

[stma]

Marie: Hoping you had a great vacation...just a quick post to let you know the water this morning is crystal clear....The metal out product was the only thing needed (I'll hold on to the ascorbic in case it's needed later in the season).

Metal out/ Poly60/ low FC levels etc etc and the water cleared inside of two days...

A very BIG Thank You to you and Lisa for mentioning metal in the first place....I never would have assumed that was the issue ...

With that said, are my days of hard shocking over ?? I'd hate to see these metals drop out again...

Thanks again

[Watermom]

A very BIG Thank You to you and Lisa for mentioning metal in the first place....I never would have assumed that was the issue

I had a feeling it might be a metals issue. I'm gonna let Marie answer your question about shocking. She is our metals expert. Glad it is looking better.

[stma]

Thanks WaterMom...as irony would have it, the water is absolutely crystal....but it smells of chlorine in a big way...CC is at 1.5, and FC is not holding at all...now the fun egins !!!

[szampino]

STMA,

I'm feeling real confident with what I've accomplished with my 'Metal infected' pool so I'm going to chime in, I've been 'Clean' for about 1 week now. I'm not sure if you are still looking for suggestions on your next steps but this is what I would reccomend.

1. Post your chemistry numbers.
2. Make sure you've got enough Metal Sequesterant on hand.

If you are going to try and tackle the FC not holding by getting to shock, I would suggest the following:
1. get your PH to 7.0
2. Let your FC drop to about 1.0
3. Add a maintenance dose of the Sequesterant (I say maintenance dose because you've already added it within a few days).
4. Let it circulate for a few hours.
5. Gradually bring your FC up to reccomended Shock Level, while maintaining a 7.0 PH.
6. Keep it there till it holds overnight, **I would even keep it one more day if possible.

***This is where my Metals fell out again and I was really bummed, but I stayed with the plan.

7. (After you FC holds) - Go to step 13 if you didn't stain.
8. Let your FC drop to the 1.0., keep PH at 7.0

***At this point I noticed that many of my stains began to dissappear automatically, must have been the Sequesterant in the water.

9. Vaccum if you have bottom staining.
10. Clean your filter or backwash.
11. Add another maintenance dose of the Sequesterant
12. Let is circulate till the staining is gone. (hopefully it is by this point)
13. Bring your FC gradually up to sanitizer level.
14. Keep you PH at 7.2-7.3 tops

Hope this helps.

[KirstenHW]

How does the ascorbic acid treatment work if you have a DE filter with no receirculate option? I have rust stains around mt light and my two skimmers that I'd like to remove with vit c but I can't recirculate my water.