Problem with Mineral Springs unit (aka Aquarite)

[cmcq]

Thanks. I'll give those things a shot. Unfortunately, I've already had the unit powered off and back on which I hoped would reset it, but maybe I didn't have it off long enough. Is there any scenario where the salt is so low that it causes issues like this? When the pool company opened the pool (yes I know I need to learn how to do this myself), I think they only add 100 lbs of salt into my 22k gallon pool b/c they said the reading on the salt was pretty close to the target range. If they were wrong and it was really low, would that make a difference? Finally, do you think I can make any use out of the numbers that appear on the unit when the I cycle through them even though the Check Cell is on? If so, should I post them?

[cmcq]

I tried the diagnostic button and killed the power as described above, but no luck. The unit was installed Oct 04 so it is still under some warranty. I'll try Goldline tech support and also the pool builder to see what they say about how to deal with it.

Side question - does anyone know what the different readings are on the unit? When it was working, I knew which was the mineral reading and which was temp, but didn't know the rest of them.

Thanks

[waste]

I don't have my service manual handy but from memory:

Push #1 is temp
#2 is volts
#3 is amps
#4 is % output
#5 is instant salinity (with a "-" in front of it
#6 is the unit model and #7 is the software revision #