Hayward SP problems...new to pools..

[JKashJ]

Great advice Al...I'll change that out tommorrow and see if that clears the pressure gauge issue. I still need to take care of the bubbles...i've been slammed at work and not able to get to it yet...

Thanks again for the great info.

[JKashJ]

Ok...changed out the gauge tonight and it immediately dropped to 15 psi. Didn't have it wrapped well with teflon tape..i think i went the wrong direction with it...anyhow, a small leak is coming from the threads at the gauge, so i'll fix that tommorrow.

Tightened the two screws on top of the sand filter and checked the gasket at the basket just before the pump...i've still got bubbles coming in. I can't find a spot where water is leaking anywhere(would that be the case if air is getting in?)

I did move it to recirculate, but i didn't notice any change with the bubble issue after that. I know Aylad mentioned checking the gaskets and seals...other than the one in the basket, where else would you recommend checking?

Thanks,

Kash

[JKashJ]

Now the leak in the gauge is fixed. I'm running between 12 and 14 psi. I've read on here about taking the top off of the sand filter and cleaning some fo the parts inside. Is that something i need to do as I start things up in the spring?

[Watermom]

I have never messed with my sand. This will be my eighth season with my sand and I have never had to clean it or anything else. Still just fine. A pressure reading of 12-14 is just fine. When you get a 8-10 psi rise in the filter pressure, that will indicate when it is time to do a backwash.

[Poconos]

If it's easy to pop the top and easily peek inside go ahead and do it but it probably isn't necessary. I take my valve assembly inside every winter anyhow and, like Watermom, never had to do anything to the sand for 10 seasons. As for air leaks, any joint ahead of the pump inlet can be suspect. All it takes is a tiny place for air to be sucked in. You can take something like petroleum jelly, vaseline, and smear it around any suspect joints. Much cheaper than silicon grease. If you locate something then we'll deal with fixing it. When done, wipe off the lube and clean any residue with alcohol, paint thinner, or anything that will clean off the lube and evaporate. Anoither source of air could be low water level and you get a vortex in the skimmer and momentary suction of air. You should be able to hear that though...pretty loud.
That's it for now.
Al

[JKashJ]

Thanks for all the details....today is pool day for me, so i'll go thru the suggestions and see what comes of it.

Kash