As I’ve discussed in other threads, I appear to have a leak in my ag pool liner. In the course of inspecting the pool, I’ve noticed an issue with sidewall warping and pulling away from the stabilizer rail under the top rail. I have a 18’ x 36’ doughboy morning dance brand pool. The pool has a deep end approximately 3’ deeper than the standard 4’, and the pool is buried 2’ into the ground.

I’ve not inspected around the entire pool yet, I know this is happening in at least one spot. Here is a picture:

http://i23.photobucket.com/albums/b3...59-revised.jpg

As I’ve said, there is about 1’ of water as measured from the shallow end – I’m sure this has contributed to the situation. I seem to have minor buckling issues around the pool. It would seem wise to address this particular situation now rather than when the pool is full.

I’m assuming that I need to remove the top connectors on both sides of the specific top rail, and try to rework the top of the side panel so that it is “straighter and will fit back into the stabilizer rail.

http://i23.photobucket.com/albums/b3...58-revised.jpg

I assume that the stabilizer rail is not connected to the to rail; the top rail just rests on top of it.

Of course, any advise of what to do , and what not to do is appreciated.