automatic pool cleaner

[fofa]

I had a Hayward navigator, it worked pretty good for 5 years, then dead, and it cost too much to fix. So I bought a "The Poolcleaner", and so far it has been a wonder to behold. I think the Navigator covered the pool a tad better (but not by much), but this does leaves and acorns and small twigs that clogged the navigator. I leave it in 24 X 7 (maybe haul it out if we are swimming) and it stays in all winter also because I don't close my pool. Only been a year, but nothing has needed replacing, Navigator needed wings replaced once a year minimum, and nothing is looking like it is even close to wearing out. About the only wear parts would be the tire treads and "flaps" that ride on the pool surface. They have both suction side (what I have) and pressure side (no booster pump pressure type) cleaners. Might be worth a look at.
www.thepoolcleaner.com
Before I bought mine I asked around, and everyone that I ran across that had this one says it was great. So I tried it, besides it was cheaper than the hayward and much cheaper than pressure side cleaners and way, way cheaper than robotics which you have to remove each time.

Good luck with your search and what ever you get, I hope it works good for you.

[KPROMERO]

Is the poolcleaner only for inground pools or can it be used for above ground also?

[KPROMERO]

Well i went out today and bought the Polaris 65 for my pool today but they had to order. Hope it works outs. I have read that a few of you put cotton balls in the bag and does that really help get the fine stuff while using? What else would you recommend using?

[SPILL]

Hi, I've had a Polaris 65 for 3 years now and it is still going strong. The cotton balls are a must in my opinion and are inexpensive and effective. The Polaris still won't get all the fine stuff but does a good job of scooping up most common debris. One note: There is a valve on the return connector that has to be fine tuned somewhat, this controls the amount of pressure to the unit. Too much and it will bounce around and flip over, not enough and it will get stuck sometimes. Also you may have to cut the hoses per the instructions to fit your pool. This is pretty important as you don't want too much excess hose to get tangled up in.

[KPROMERO]

Thanks SPILL

[fog80]

I had a Hayward navigator, it worked pretty good for 5 years, then dead, and it cost too much to fix. So I bought a "The Poolcleaner", and so far it has been a wonder to behold. I think the Navigator covered the pool a tad better (but not by much), but this does leaves and acorns and small twigs that clogged the navigator. I leave it in 24 X 7 (maybe haul it out if we are swimming) and it stays in all winter also because I don't close my pool. Only been a year, but nothing has needed replacing, Navigator needed wings replaced once a year minimum, and nothing is looking like it is even close to wearing out. About the only wear parts would be the tire treads and "flaps" that ride on the pool surface. They have both suction side (what I have) and pressure side (no booster pump pressure type) cleaners. Might be worth a look at.
www.thepoolcleaner.com
Before I bought mine I asked around, and everyone that I ran across that had this one says it was great. So I tried it, besides it was cheaper than the hayward and much cheaper than pressure side cleaners and way, way cheaper than robotics which you have to remove each time.

Good luck with your search and what ever you get, I hope it works good for you.

how much did it cost?

[fofa]

ThePoolClearner I got online (4 wheel model) for $200.00 (give or take some change). It was a close out sale, and i see they do not carry them now.

[Peter155]

ThePoolClearner I got online (4 wheel model) for $200.00 (give or take some change). It was a close out sale, and i see they do not carry them now.

Where did you get it?