Waste
Thanks for reply

I checked the 3amp fuse and it wasnt blown. The transformer is humming however when I tested the the output wires going to the board there NOTHING so I am hoppping I only burnt out the transformer.

I found Jandy trouble manual online. It states if you shortout the wires on the JVA first check the transformer f ,then fuse ,then if both are ok then the PCB .

Will call jandy in the AM and order new Jandy transformer # 6612 .

I wll then have to figure out why the JVA is making clicking noise and stops 1/2 way turning the valve
I had manually switched the spa off when I was heating the pool ,then my father in law went into the spa started hitting buttons , He drained my spa into the pool and the JVA was making clicking sounds when I went to pumps

So now when I go to spa mode it seem to not turn all the way to spa mode without me helping it by hand and stops and start clicking. I am guessing I needed to adjust it. Seems like all the gear inside the JVA arent worn like I expected to see.

Dam father in law .He should have asked first .This is not like has above ground pool

GB

Does anyone here sell Jandy parts ??????? if so please email me tampavii@aol.com