broken polaris pump

[sunofthebeach]

My polaris pump is broken. When I turn it on it just hums.

It makes a noise so I know it is getting elec.

What do I check next.

This is my 4th season with the pump, I do run it 8 hours a day everyday all season long.

[thepoolman1]

This problem sounds like there was a seal leak that allowed water to damage and "seize" the front bearings in the pump. This most often happens when the pump runs dry. The seal will generate a lot of heat from friction and melt the impeller and possibly the sealplate/bracket. The best option is a new pump. Have a qualified pool-tech check it.

[waste]

This problem sounds like there was a seal leak that allowed water to damage and "seize" the front bearings in the pump. This most often happens when the pump runs dry. The seal will generate a lot of heat from friction and melt the impeller and possibly the sealplate/bracket. The best option is a new pump. Have a qualified pool-tech check it.

While that may very well be what's going on, I suggest giving the motor a few 'hits' with either a 2X4 or the butt end of a hammer's handle, while the pump is running - there is always the chance that the starter switch is just a little rusted (though, this can also be caused by shaft seal failure). Poconos knows this better than I, he may have some better advice. If the 2X4 advice works, there are ways to clean the slightly corroded connections If this doesn't work - open the back of the motor and try to turn the shaft with a screwdriver, if it's only slightly seized, it should turn for you ~fairly easily.

The problem may just be moisture getting into the unit over the past 4 years and causing slight corrosion, which can be dealt with by doing what I said. If all else fails, a new motor is in order -- should you find that you need a new motor, we, here, can 'walk' you through the replacement.

I sincerely hope that you can fix this without having to replace the motor! If you need any other help with this, we'll be here!!

[aquarium]

Anything that can't be fixed by whacking it with a 2x4 just isn't worth having anyway.

[sunofthebeach]

I see a replacement pump is $250. It looks really simple to swap out, so If whacking it with a board and taking it apart does not work, I am pretty sure I can solve this problem.

thanks for the info.


What do I do to keep this from happening again 2 years from now?

[waste]

Good luck with the fix/ replacement! Let us know if you need any advice

Preventing it from happening again depends on what the original problem was. If it was the shaft seal, just periodicly check for drips under the pump - if you see some one of the seals needs to be replaced before the leak can do damage. If it's slight corrosion freezing things up, try to keep the motor as dry as possible and treat the connections with an approved rust inhibitor. Avoid splashing chemical leaden pool water on the pumps. Finally, hope for a better pump this time

[sunofthebeach]

Anything that can't be fixed by whacking it with a 2x4 just isn't worth having anyway.

I opened my pool today. The polaris booster pump was just humming. (I never fixed the problem last season, I just closed the pool)

I hit the pump with a hammer and it started to work!

[waste]

I opened my pool today. The polaris booster pump was just humming. (I never fixed the problem last season, I just closed the pool)

I hit the pump with a hammer and it started to work!

You can thank Al for that one, I was just 'parroting' his recommendation. Glad that it worked!!