All my pvc held without leaks, but it looks like the electricians that put my cord on my pentair 2 speed did not hook it up right. Either that or something is damaged. I am only getting low speed.

My main question since I am not sure if this is just a hook up issue or something else....what is a typical low speed pressure for a 3/4 HP motor through a sand filter. I am at about 3psi now. Seems like a good flow through my return, but I am curious. I had an overpowered pump 1.5hp hooked up earlier and was getting 13 psi, but it seemed way to much for my 24ft ABG.