What size sand filter and pump?

[b2001]

1. As I said before - 18 x 36, 14,000 gallon ag pool withPurex Triton Maxim pump, AO Smith BN35 motor (1-1/2 hp), it is marked "HP 2.0 SPL", and a Pentex 150 sq ft cartridge filter. How is this combo?

2. I'm not sure what I would be doing to maintain the cartridge incorrectly. I thoroughly wash it down many times during the course of a summer as the pressure rises. I usually have two on hand that I will swap out every week or two.

3. That could be the case, although the cartridges are not actually "destroyed". I've got three sitting around from last year. They just become ineffective and I can't get my water clear after a rain. The pressure will rise, I'll remove the cartridge and clean it, and when I reinstall it and start the system, the pressure shoots back up high.

I really feel like last year was the first time that I got a good handle on chemicals, scrubbing, and scrubbing and getting the pool clean. It was still not 100%, but close. However, it would take longer and longer to recover from each successive storm to the point where these cartridges were just not working right, and pool quality kept going down.

I'm definitely switching from baquacil - I'm reading everything on this site that I can ...

I'm open to any suggestions. Thanks for your responses, Carl ...

[CarlD]

Try soaking the ineffective carts in Cascade automatic dishwasher detergent, the powder. If that doesn't work, try soaking them in Muriatic Acid--what have you got to lose if they are clogged anyway?

Switching over from Bacq may be your best answer. Be prepared with lots and lots and lots of chlorine...I'd suggest getting the 5 gallon carboys of 12% from the pool store--there's usually a deposit on the carboy, but you only pay it once. I'd get two and as one was empty I'd get a replacement--it may cost a little more (maybe not--depends on prices) but disposal becomes a non-issue.

Normally, I'd say just buy the bleach, but with the amounts you'll need for the switch, the carboys may make life MUCH easier. Besides, if you can get 12% for $15, that's like getting 10 gallons of Ultra bleach for $15.--$1.50/gallon. Around here, Ultra is now running $1.80/gallon (.45/quart).

I only said that those are the possible reasons for your yearly purchases.

I have never understood the attraction of Bacquacil, or Bromine.

[b2001]

I only said that those are the possible reasons for your yearly purchases.

Sorry, if I came across wrong, I'm just trying to get to the bottom of my issues - I've had some frustrating times in the past.

I have never understood the attraction of Bacquacil, or Bromine.

New pool owner ignorance coupled with advice from the pool dealer - if I only knew then what I know now...

What I heard from the dealer was that baquacil would not have that chlorine smell, and would be easy to use - which sold me. I didn't hear anything about a lot higher costs, etc. Bottom line is I really didn't do my homework - but other than this forum, most of the information out there seems to be provided by pool chemical product manufacturers and pool supply dealers. I guess there's no substitue for experience.

I've done the muriatic acid thing - too messy, and not enough of a benefit that I could see.

I had never heard of a carboy - I'll check with a pool place tomorrow. Looks like that's what I need. My baquacil was at 50 ppm last week. I emptied my pool down to 16" and refilled it back up and it seems to be down to from 0 to 15 ppm. I'm hoping that will reduce the mess during conversion.

[CarlD]

Sorry, if I came across wrong, I'm just trying to get to the bottom of my issues - I've had some frustrating times in the past.

Not a problem.

New pool owner ignorance coupled with advice from the pool dealer - if I only knew then what I know now...

Been there, done that. So have most of us....

What I heard from the dealer was that baquacil would not have that chlorine smell, and would be easy to use - which sold me. I didn't hear anything about a lot higher costs, etc. Bottom line is I really didn't do my homework - but other than this forum, most of the information out there seems to be provided by pool chemical product manufacturers and pool supply dealers. I guess there's no substitue for experience.

Makes used car salesmen look good, don't they?

I've done the muriatic acid thing - too messy, and not enough of a benefit that I could see.

I had never heard of a carboy - I'll check with a pool place tomorrow. Looks like that's what I need. My baquacil was at 50 ppm last week. I emptied my pool down to 16" and refilled it back up and it seems to be down to from 0 to 15 ppm. I'm hoping that will reduce the mess during conversion.

A carboy is just a name for the 2.5 and 5 gallon reusable blue jugs they use to sell liquid chlorine. You give a deposit on the jug, but you can either get it back, or trade the empty--like a deposit bottle...