I would be checking the chlorine to make sure you aren't in the middle of an algae bloom. If the SWCG was just started, you very well may be. If he shocked it, it may indicate you have a metal problem with your water.
I would be checking the chlorine to make sure you aren't in the middle of an algae bloom. If the SWCG was just started, you very well may be. If he shocked it, it may indicate you have a metal problem with your water.
It is the salt level. The "good" range just means that there is adequate salt and that it is producing chlorine. I want to give it a chance to do it's job. I just wondered if the actual addition of the salt could be responsible for the color change - it was a pretty rapid change, faster than I would anticipate for a simple algae bloom.
Last edited by SeanB.; 11-09-2006 at 11:44 PM.
Site owner -- www.troublefreepool.com
I saw no color change when I added the salt to my pool...
14'x31' kidney 21K gal IG plaster pool; SWCG (Saline Generating System's SGS Breeze); Pentair FNS Plus 48 DE DE filter; Whisperflow 1 HP pump; 8 hours hrs; kit purchased from Ben; utility water; summer: none; winter: none; PF:5.7
We had no color change either last week when our SWG was finally started. At 100% output for 24-hours, our SWG got the chlorine level well above 3.0 in our 10,000 gallon FG pool, but not nearly high enough to shock to clear an algae bloom.
Pool has cleared up. I used the swcg to shock to 24 hours and then had all chemicals checked - low on cya and calcium, high on pH.
Corrected levels and pool is blue and gettting clearer daily.
Site owner -- www.troublefreepool.com
Bookmarks