Geralde Pool build

[SeanB.]

Nice. What is the are on the lower left in the last picture going to be? Is that a beach entry? I see steps on the opposite side.

[geralde]

it is a Play pool. It is 18inches deep...about 100 Sq Ft. We think that is where I will be spending alot of time with a cooler :-)

The pool is a A&S 700SqFt Mountain Lake. Approx 22x42. That is not including the playpool.

Looks like I will be getting Tile and Coping tomorrow. Decking later this week.

Here is a better pic of the play pool.

[SeanB.]

it is a Play pool. It is 18inches deep...about 100 Sq Ft. We think that is where I will be spending alot of time with a cooler :-)

Great idea. My four year old would love an area like that.

[divnkd101]

[QUOTE=geralde;39183]it is a Play pool. It is 18inches deep...about 100 Sq Ft. We think that is where I will be spending alot of time with a cooler :-) /QUOTE]

Geralde, Great idea. We did a little version of what you have (4ft x 9ft). We refer to it as our tanning ledge. Are you putting any circulation in the area? I did not see any stub-outs. We installed a "bubbler" fountain to help keep the debris off of the landing. I also installed an umbrella holder as well. Here is the shot of ours.

http://i112.photobucket.com/albums/n...1/06092357.jpg

[geralde]

Just wanted to post a few updates. Tile and Coping are done. Electric was done yesterday..and decking will be done Monday. Moving right along :-)

[eljefe281]

Looks terrific!

[divnkd101]

Geralde,

I saw your post on Sean B.'s thread. I wanted to put my two cents in on the exposed aggregate. Pea Gravel is great as long as the builder installs the correct grade of gravel. I am attaching a picture (not the best quality) of my folks pool in Seabrook, TX. They have pea gravel with the flagstone inlay. Hope this gives you some ideas.

[geralde]

Sharing some updates:

[divnkd101]

Looks good. Did you make any decisions on your decking yet??