+ Reply to Thread
Results 1 to 8 of 8

Thread: Wall height difference...

Hybrid View

  1. #1
    Join Date
    Apr 2006
    Location
    Apache Junction, Az
    Age
    70
    Posts
    475

    Default Re: Wall height difference...

    You are very welcome CliffTex, hope those kids enjoy the pool. I know mine always have.

    We really are on the same page Matt. We both agree the ground prep is the most important part of the job. Build the pool on firm solid ground and whatever method of leveling you choose, do it good. The rest will go fairly easy.

    As for the one inch rule. When building your pool forget it. Set everything perfect. Take the time to make it perfect by whatever means you have available. The one inch rule applies after the pool is full.

    It is not uncommon for the ground to settle due to many factors. When you measure from the top rail to the water level all the way around the pool it should be within an inch.

    If it is not, that's when the questions arise. Is it safe? Should I drain it ASAP and redo? That's when I say let's take a look at your particular situation and see what would be best. No hard fast rules here, just some good pool sense.

    Have a good one, Dennis
    AG pool installer
    Arizona

  2. #2
    NWMNMom is offline Registered+ Widget Weaver NWMNMom 0
    Join Date
    Nov 2004
    Location
    WAAAY NW Minnesota
    Posts
    461

    Default Re: Wall height difference...

    Ours was so perfectly level (I made my DH crazy with the transit several times a day during install) when we prepped and installed in our usually wet yard and then we had the "big drought" this summer (biggest in the northern plains since 89) and even a lot of the normal subsoil moisture dried up. So, long story short, our "plump" ground shrunk and shifted slightly back there and I do notice a slight difference of maybe 1-1.5" or so - not side to side but from one end to the other. I'm hoping that we do not have an unusually wet fall or spring.....
    Beats driving to the lake!
    18'x33'x52" AG oval, hard plumbed system, 22" Pentair Meteor Filter 1.5hp pump, Goldline SWCG System, 2/4x20 SolarBear Panels, Biltmore Steps - 16x14' composite deck, Pool Rover Jr

+ Reply to Thread

Similar Threads

  1. How do I accurately determine the height of a beaded liner for an AGP?
    By yardbird in forum Above-Ground Pool Construction & Repair
    Replies: 3
    Last Post: 07-14-2012, 07:59 PM
  2. Foam Wall Liner won't stay attached to pool wall
    By pdxpool in forum Above-Ground Pool Construction & Repair
    Replies: 0
    Last Post: 07-02-2012, 03:24 PM
  3. bond beam/form height question
    By cdocon in forum In-Ground Pool Construction and Repair
    Replies: 1
    Last Post: 03-16-2012, 05:03 PM
  4. Measuring Height for Liner Replacement
    By cooper in forum Above-Ground Pool Construction & Repair
    Replies: 3
    Last Post: 05-12-2011, 12:05 AM
  5. Maximum riser height of pool steps
    By eljefe281 in forum In-Ground Pool Construction and Repair
    Replies: 7
    Last Post: 07-30-2006, 12:10 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts